Heat & Glo LifeStyle CERONA-42 1Listing and Code Approvals, High Altitude Installations

1Listing and Code Approvals

A.Appliance Certification

MODEL: CERONA-36, CERONA-42

LABORATORY: Underwriters Laboratories, Inc. (UL)

TYPE: Direct Vent Gas Fireplace Heater

STANDARD: ANSI Z21.88b-2005•CSA2.33b-M2005•UL307B

This product is listed to ANSI standards for “Vented Gas Appliance Heaters” and applicable sections of “Gas Burn- ing Heating Appliances for Manufactured Homes and Rec- reational Vehicles”, and “Gas Fired Appliances for Use at High Altitudes”.

NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE. This appliance is tested and approved as either supplemen- tal room heat or as a decorative appliance. It should not be factored as primary heat in residential heating calculations.

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the National Fuel Gas Code, ANSI Z223.1-latest edition in the U.S.A. and the CAN/CGA B149 Installation Codes in Canada.

C. High Altitude Installations

U.L. Listed gas appliances are tested and approved without requiring changes for elevations from 0 to 2000 feet in the U.S.A. and Canada.

When installing this appliance at an elevation above 2000 feet, it may be necessary to decrease the input rating by changing the existing burner orifice to a smaller size. Input rate should be reduced by 4% for each 1000 feet above a 2000 foot elevation in the U.S.A., or 10% for elevations between 2000 and 4500 feet in Canada. If the heating value of the gas has been reduced, these rules do not apply. To identify the proper orifice size, check with the local gas utility.

If installing this appliance at an elevation above 4500 feet (in Canada), check with local authorities.

WARNING

Do NOT use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

This model may be installed in a bedroom or bed-sitting room in the U.S.A. and Canada.

B.BTU Specifications

Model		Maximum	Minimum	Orifice
				Size
(U.S. or Canada)		Input BTUH	Input BTUH	(DMS)
	US	37,500	25,000	32
Cerona-36 (NG)	(0-2000 FT)
	CAN	33,750	22,300	33
	(2000-4500 FT)
	US	45,000	32,000	29
Cerona-42 (NG)	(0-2000 FT)
	CAN	40,500	28,800	30
	(2000-4500 FT)

E. Non-Combustible Materials Specification

Material which will not ignite and burn. Such materials are those consisting entirely of steel, iron, brick, tile, concrete, slate, glass or plasters, or any combination thereof.

Materials that are reported as passing ASTM E 136, Stan- dard Test Method for Behavior of Materials in a Verti- cal Tube Furnace at 750oC, shall be considered non-com- bustible materials.

F. Combustible Materials Specification

Materials made of or surfaced with wood, compressed pa- per, plant fibers, plastics, or other material that can ignite and burn, whether flame proofed or not, or whether plastered or unplastered shall be considered combustible materials.

Heat & Glo Quality Systems registered by SGS ICS

4 Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. A • 6/06