Bosch Appliances General Information, F220-B6 Series Detector Bases, Compatible Control Panels

F220 Series Detectors with F220-B6/C/E/R Bases		General Information en 3
	use a can of clean, dry compressed air (such as TECHSPRAY
	ENVI-RO-TECH Duster) which is available at office and alarm
	supply stores. Shorten the plastic tube that comes with the
	compressed air to about 2 in. (5 cm). Place the tube or needle
	valve through the Chambermaid valve in the bottom of the
	detector (refer to Figure 2.2 on page 7).
i	NOTE! Do not paint the detectors. Paint or other foreign
	matter covering the detector can prevent smoke
	detection.
2	General Information
	This document covers mounting, wiring, power requirements,
	testing, and maintenance for the F220-B6, F220-B6C, F220-B6E,
	and F220-B6R Detector Bases and the F220 Series Heat and
	Photoelectric Smoke Detectors. Install them according to
	NFPA 72.
i	NOTE! For proper system installation, read and
	understand NFPA-72 before installation.
	For installation guidelines, refer to Installation Considerations
	for Smoke and Fire Detectors (P/N: 26715).

2.1F220-B6 Series Detector Bases

2.1.1Compatible Control Panels

Two-wire:

NOTE! Bosch Security Systems, Inc. makes no claim written, oral, or implied that the F220 Series Detectors

i work with any two-wire control panels except those specified in the Base Compatibility chart in Technical Service Note (P/N: 4998148185).

Bosch Security Systems, Inc. Installation Manual 4998138694 -04 2007.01