Bosch Appliances F220-B6 installation manual Base Comparisons

Page 4

4 en General Information

F220 Series Detectors with F220-B6/C/E/R Bases

 

 

Four-wire: Compatible with all UL Listed four-wire control panels. Refer to the control panel manufacturer’s installation instructions for proper end-of-line (EOL) resistor selection.

2.1.2Base Comparisons

The F220-B6 is a two-wire base, while the F220-B6C, F220-B6E, and F220-B6R are four-wire bases. All three of the four-wire bases have a Form A alarm relay. In addition to the alarm relay, the:

F220-B6C has a Form C auxiliary alarm relay

F220-B6E has a power supervision (EOL) relay

NOTE! Use the F220-B6RS when a built-in sounder is needed. The F220-B6RS also has a Form A alarm relay. Refer to the F220 Series Detectors with the F220-B6RS

i Installation Manual (P/N: F01U029847).

For addressable systems, use the F220-B6PM Addressable POPIT Master Base or F220-B6PS Addressable POPIT Base. Refer to the F220-B6PS/M Installation Manual (P/N: 4998149982).

4998138694 -04 2007.01

Installation Manual

Bosch Security Systems, Inc.

Image 4
Contents F220 Series Detectors with F220-B6/C/E/R Bases Legal Required Maintenance and TestingTrademarks F220-B6 Series Detector Bases General InformationCompatible Control Panels Base Comparisons Base Features F220 Series Detectors About F220 Series Detector Heads2 F220 Series Detector Features 3 F220 Series Heat Detector HeadsGeneral Specifications Technical Specifications4 F220 Series Smoke Detector Heads Detector Specifications Base SpecificationsElectrical Supervision Install the Bases Mount the BasesWire the Bases Loop Wiring SpecificationsTerminal Connections EOL ResistorsWire Optional Remote Annunciators Four-wire Loop TerminationWire F220-B6 Two-wire Bases Wire F220-B6C/E/R Four-wire Bases1 F220-B6C 2 F220-B6EF220-B6E 3 F220-B6R F220-B6RWire F220-B6E Power Supervision Base Wire Power Supervision ModulesWire D275 Power Supervision Module Mount the Detector Heads Install the Detector HeadsOptional Locking Bar Mounting Skirt LEDDetector Head Keyed. Do not force them onto the mounting basesSensitivity Mode Test ModeSet Detector Modes Set CleanMe Feature Flash Rate and Trouble IndicationTest the Installation Inspect the InstallationReset the Control Panel Activate an Alarm at Each DetectorTest Each Detector Perform Nfpa 72 Required Testing Test the Alarm LoopTest CO Sensors Page Page USA