8 en General Information | F220 Series Detectors with |
|
|
2.2.4F220 Series Smoke Detector Heads
The F220 Series Smoke Detector Heads are UL Listed, open- area photoelectric smoke detectors that work with commercial fire protective signaling systems and household fire warning systems. Select the appropriate mounting base to configure the detectors for
Section 2.1.2 Base Comparisons on page 4).
To verify power to the detector and a functioning smoke sampling circuitry, a dual color LED indicator flashes green every eight seconds when operating normally. It flashes once every four seconds when a trouble condition exists. If the detector determines an alarm condition exists, the LED changes from flashing green to steady red. The detector returns to normal when power is interrupted and the alarm condition clears.
Throughout its normal life cycle, the smoke detector monitors and periodically adjusts itself to keep the sensitivity at its factory calibrated level. When excessively dirty, the detector’s LED flash rate changes from an eight second flash rate to a four second rate. If CleanMe is selected, the detector sends a CleanMe signal to the compatible control panel to indicate a dirty smoke detector.
Refer to Section 4.3 Set CleanMe Feature on page 22.
2.3Technical Specifications
2.3.1General Specifications
Air Velocity | 4000 ft/min (1200 m/min) maximum |
|
|
Operating | +32°F to 100°F (0°C to 38°C) |
Temperature |
|
|
|
Relative | 0% to 95% |
Humidity |
|
|
|
Table 2.3 Specifications - Detectors and Bases
4998138694 | Installation Manual | Bosch Security Systems, Inc. |