Hearth and Home Technologies II-B owner manual Finishing, Mantel Projections, Facing Material

8 Finishing

A. Mantel Projections

Figure 8.1 shows the minimum vertical and corresponding maximum horizontal dimensions of appliance mantels or other combustible projections above the top front edge of the appliance.

Interior		CEILING
View
NON-COMBUSTIBLE BOARD
	(SUPPLIED ON APPLIANCE)
	INDOOR SIDE ONLY
		12
	10	11
		35-3/4
	9
	8
	7	13-5/8
	6	12-5/8
	11-5/8
	10-5/8
	9-5/8
	8-5/8
HOOD	7-5/8
	Note: Measurements
	are in inches.
Figure 8.1 Indoor Clearances to Mantels or other
Combustibles above Appliance

Top View

MEASURED

FROM CORNER

Inside Facing Material

•May install combustible materials up to specified clearances on top, front and sides of appliance.

•Seal joints between finished wall and appliance top and sides with 300º F (140º C) minimum sealant.

•Leave space so bottom grille can be lowered for trim door removal.

NON-COMBUSTIBLE ZONE

41-7/8 in. 2-3/4 in.

Figure 8.3 Non-combustible Zone (Interior)

Outside Facing Material

OVERHANG

FIREPLACE

HOOD

½ IN.

A	SIDING	A	B
			A

Figure 8.2 Clearances to Combustible Mantel Leg or Wall Projections (Acceptable on both sides of opening.)

B. Facing Material

WARNING

Fire Risk.

Do NOT obstruct air inlet or outlet grilles. Do NOT modify grilles.

• Modifying or covering grilles could cause temperature rise and fire hazard.

Finishing materials must not interfere with:

•Air flow through grilles or louvers.

•Operation of louvers or doors.

•Access for service.

SIDING SIDING

	Vinyl	Non-vinyl
A	36 in.	12 in.
B	64-5/16 in.	35-5/16 in.

Figure 8.4 Exterior View - Minimum Clearances

Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. G • 8/07 21