Hearth and Home Technologies II-B owner manual Mantel Projections Indoor only, Ceiling

Page 9

C. Mantel Projections - Indoor only

CEILING

NON-COMBUSTIBLE BOARD

(SUPPLIED ON APPLIANCE)

INDOOR SIDE ONLY

TOP VIEW

MEASURED

FROM CORNER

		12
	10	11			35-3/4
		11


	9


7	8		13
7			13	-5/8
6		12-	5/8

11-5/8

10-5/8

9-5/8

FIREPLACE

HOOD

½ IN.

8-5/8

HOOD 7-5/8

Note: Measurements are in inches.

Figure 3.4 Indoor Clearances to Mantels or other Combustibles above Appliance

Figure 3.5 Indoor clearances to Mantel Legs or Wall Projections (Acceptable on both sides of opening.)

Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. G • 8/07

9

Image 9

Contents Model Twilight-II-B Homeowner Reference Information CongratulationsTable of Contents Listing and Code Approvals Requirements for the Commonwealth of Massachusetts Installation of Carbon Monoxide DetectorsGetting Started Design and Installation ConsiderationsTools and Supplies Needed Inspect Appliance and ComponentsSelecting Appliance Location Framing and ClearancesFire Risk Odor Risk ClearancesCeiling Mantel Projections Indoor onlyAppliance Opening Minimum Clearances Termination LocationsAppliance Preparation Removing Non-combustible Facing Material AssemblySecuring and Leveling the Appliance Placing Metal Hearth StripPlacing Flashing and Sheathing Placing and Securing ApplianceRisk of Fire Apply housewrap or building paper19 Attaching Non-combustible Facing Material Installing Non-combustible Facing Material Outdoor SideFuel Conversions Gas Connection Gas InformationGas Pressures Pressure Natural Gas PropaneHigh Altitude Installations Recommendation for Wire Connecting to the ApplianceElectrical Information Fan location Optional AccessoriesOptional Accessories Requirements Intelliﬁre Ignition System WiringWall Switch Installation for Fan Optional Junction Box InstallationFinishing Mantel ProjectionsFacing Material Risk of Fire Detail Clean the Appliance Appliance SetupAccessories Lava Rock and Ember PlacementLog Set Assembly LOGS-TWI Positioning the LogsInch Sharp Notch Sharp Notch Smooth CutoutShutter Settings Glass AssemblyRemoving Glass Assembly Replacing Glass AssemblyBefore Lighting Appliance Operating InstructionsIntelliﬁre Ignition Lighting ApplianceFrequently Asked Questions Initial Break-in ProcedureAfter Appliance is Lit Troubleshooting Intelliﬁre Ignition SystemSympton Possible Cause Corrective Action Symptom Possible Cause Corrective Action Maintaining and Servicing Appliance Maintenance TasksRecommend addition of screen if one is not present Inspect Maintenance TasksReference Materials Appliance Dimension DiagramLog Set Assembly Service PartsService Parts List IPI Valve Assembly Limited Lifetime Warranty Heat & GLO GAS Appliance Products Limited Lifetime WarrantyDo not Discard this Manual Contact Information