Hearth and Home Technologies C-40 warranty Firebrick Replacement

C. Firebrick Replacement

The firebox of your fireplace is lined with high quality firebrick, which has exceptional insulating properties. There is no need to use a grate; simply build a fire on the firebox floor. Do not operate the fireplace without bricks.

IMPORTANT: The bricks are very similar in size. Be certain you have the proper brick in the correct location. Measure the brick size for accuracy.

After the coals are completely cooled, remove all old firebrick and ash from unit and vacuum out firebox.

1.Remove new brick set from box and lay out to diagram as shown in Figure 60.1.

2.Lay bottom bricks in unit.

3.Install rear bricks on the top of the bottom bricks.

Slide top of bricks under clip on back of firebox wall and push bottom of brick back.

4.Install side bricks. Slide top of brick under clips on side of firebox and push the bottom of the brick until it is flush with the side of the unit.

	2	1	1	1	2
	3				3
3					3
			3		3
3		4			3
					4
		1		1
Figure 60.1	Brick Pattern

Use Part SRV7000-306 when ordering individual brick. Provide brick dimension or copy this page, mark the desired brick and take it to your authorized dealer.

	2	1	1	1	2
	3	3		3	3
	3	4		4	3
	3	1		1	3
Figure 60.2	Brick Pattern

#	Brick Size	Qty. In Set
1	13-1/4” x 4-1/2” x 1-1/4”	5
2	13-1/2” x 4-1/2” x 1-1/4” w/ 1-1/2” chamfer	2
3	12” x 4-1/2” x 1-1/4”	8
4	12-1/2” x 4-1/2” x 1-1/4”	2

Page 60 Heatilator • Constitution EPA Fireplace • 480-1091C November 11, 2008