2.3.5 POWER CORD
1.Remove the control box. (Refer to section 2.1.2)
2.Disconnect the grounding screw from the control box.
3.Disconnect 2 receptacles.
4.Remove a screw which fastens the clip cord.
5.Separate the power cord from the control box. (See Figure 17)
6.
(Use only one 
for ground connection.)
7.If the supply cord of this appliance is damaged, it must be replaced by an exact replacement part. (The special cord means the cord which has the
same specification marked on the supply cord | Figure 17 |
fitted to the unit.) |
|
2.3.6 P.C.B.
1.Remove the escutcheon.
2.Remove the two knobs.
3.Remove the 2 screws which fasten P.C.B. cover.
4.Disconnect all the leads which connected to the P.C.B.
5.Remove the two screws which fasten the P.C.B. board.
6.
Figure 18
Copyright ©2008 LG Electronics. Inc. All right reserved. | - 13 - |
Only for training and service purposes | LGE Internal Use Only |
|