LG Electronics LP121HEM-Y8 manual Leveling Leg Assembly

Leveling Leg Assembly

To install the leveling leg assembly, complete the following:

1.Drill two 1/8-inch holes in each side of the wall sleeve, as shown in Figure 48, using the leveling leg assembly as a template. Locations near the front of the sleeve provide more support.

2.Adjust the leveling legs to the approximate height needed and install them on either side of the wall sleeve, using the screws provided. Bottom of wall sleeve can be anywhere from three to five inches above the screw base. Caulk around screws to prevent water leaks.

3.Level the sleeve horizontally from side-to-side. Provide a slight slope (one-quarter bubble in the sight glass) toward the outside. Check the level again after the unit has been installed. Adjust the legs as needed.

Figure 48 - Leveling Leg Assembly

Installation on Wall Sleeve

1.Drill four 1/8-inch diameter holes in the wall sleeve, two on each side, using the leveling legs as a template. Caulk around screws to prevent water leaks.

2.Attach the legs to the wall sleeve, using the screws provided.

3.Adjust the leveling legs to level the wall sleeve from side to side and provide a slight pitch to the outside (one-quarter bubble in sight glass).

Figure 49 - Leveling Leg Installation on Wall Sleeve

1/8" Diameter holes

(four required per unit field-drilled)

Leveler Bracket

Speed Grip Nut

Adjuster Screw

1/2"

1"

1/4"

NOTES:

1.Two leveling legs are supplied in each kit.

2.One kit is required per unit.

3.Four mounting screws are provided in each kit.

Copyright ©2008 LG Electronics. Inc. All right reserved.	- 32 -
Only for training and service purposes	LGE Internal Use Only