LG Electronics 3828A20025U Operation, Be sure the installation area does not deteriorate with age

Page 5

Safety Precautions

Do not modify or extend the power cable.

Be cautious when unpacking and installing the product.

• There is risk of fire or electric shock.

Sharp edges could cause injury. Be especially careful of the case edges and the fins on the condenser and evaporator.

For installation, always contact the dealer or an Authorized Service Center.

Do not install the product on a defective installation stand.

• There is risk of fire, electric shock, explosion, or injury.

It may cause injury, accident, or damage to the product.

Be sure the installation area does not deteriorate with age.

If the base collapses, the air conditioner could fall with it, causing property damage, product failure, and

personal injury.

Do not let the air conditioner run for a long time when the humidity is very high and a door or a window is left open.

Moisture may condense and wet or damage furniture.

Operation

Do not store or use flammable gas or combustibles near the product.

• There is risk of fire or failure of product.

4Floor Standing type Air Conditioner

Image 5
Contents No A20025U LG Floor Standing Type Air Conditioner Table of Contents Be sure not to do Be sure to follow the instruction InstallationAlways ground the product Use the correctly rated breaker or fuseOperation Be sure the installation area does not deteriorate with ageUse two or more people to lift and transport the product Installation or repair of product Drained away properlyKeep level even when installing the product Outdoor unit Selection of the best locationIndoor unit Piping length and the elevation Refrigerant amount Indoor Unit InstallationOutdoor unit Installation Selecting the locationOutdoor Unit Installation guide at the seasideInstallation works Descriptions Installation MethodInstallation Parts, Tools Use Preparation of installation parts and toolsPreparation of Piping Move the indoor tubing and drain hose to the hole Precautions in bendingConnection of piping Wiring DetailsB Connecting the Cable to Indoor UnitConnect wires to the terminals on the control Connecting pipings to the outdoor unitConnecting the cables to the outdoor unit Wiring Power Supply and WiringPower supply Vacuum Drying of the Connecting Pipes and the Indoor Unit Form the Piping Final Check and Test Run