LG Electronics 3828A20025U manual Installation or repair of product Drained away properly

Page 6

Safety Precautions

CAUTION

Installation

Always check for gas (refrigerant) leakage after

Install the drain hose to ensure that water is

installation or repair of product.

drained away properly.

• Low refrigerant levels may cause failure of

• A bad connection may cause water leakage.

product.

 

 

 

 

 

 

 

 

 

 

 

ENGLISH

Keep level even when installing the product.

• To avoid vibration or water leakage.

Do not install the product where the noise or hot air from the outdoor unit could damage the neighborhoods.

• It may cause a problem for your neighbors.

90˚

Use two or more people to lift and transport the product.

Do not install the product where it will be exposed to sea wind (salt spray) directly.

• Avoid personal injury.

• It may cause corrosion on the product.

 

Corrosion, particularly on the condenser and

 

evaporator fins, could cause product

 

malfunction or inefficient operation.

Installation Manual 5

Image 6
Contents No A20025U LG Floor Standing Type Air Conditioner Table of Contents Always ground the product InstallationBe sure not to do Be sure to follow the instruction Use the correctly rated breaker or fuseBe sure the installation area does not deteriorate with age OperationInstallation or repair of product Drained away properly Keep level even when installing the productUse two or more people to lift and transport the product Selection of the best location Indoor unitOutdoor unit Piping length and the elevation Indoor Unit Installation Outdoor unit InstallationRefrigerant amount Installation guide at the seaside Selecting the locationOutdoor UnitInstallation Method Installation works DescriptionsPreparation of installation parts and tools Installation Parts, Tools UsePreparation of Piping Precautions in bending Connection of pipingMove the indoor tubing and drain hose to the hole Connecting the Cable to Indoor Unit Wiring DetailsBConnecting pipings to the outdoor unit Connecting the cables to the outdoor unitConnect wires to the terminals on the control Power Supply and Wiring Power supplyWiring Vacuum Drying of the Connecting Pipes and the Indoor Unit Form the Piping Final Check and Test Run