3.Handle adapter
4.Hose
5.On/o switch
6.Handle
7.Variable power control
8.Cord rewind
9.Floor head
10.Crevice tool
11.Flip down brush
12.Upholstery tool
Assembly
Connecting the hose (fig. A)
•Insert the hose connector (13) into the inlet (14) of the appliance.
•Press firmly until it clicks into place.
Disconnecting the hose (fig. A)
•Press and hold the hose release buttons
(15).
•Pull the hose connector (13) out of the inlet (14) of the appliance.
Fitting the extension tubes (fig. B)
•Firmly push handle adaptor (3) in to the one of the extension tubes (2) then firmly push the additional extention tube onto the first extention tube.
Fitting accessories (fig. C)
The crevice tool (10) with flip down detail brush (11) allows for vacuuming in narrow and
The upholstery tool (12) allows for vacuuming on furniture, blinds, curtains, windows and stairs.
ENGLISH
The floor head (9) is used for dry vacuuming.
The accessories can be fit on both the handle adaptor (3) and the extension tubes
(2).
•Firmly push the accessory onto the handle adaptor (3) or extention tube (2) as required.
•To remove an accessory, pull the accessory from the handle adaptor or the extension tube.
Note: When not in use the the floor head
(9)can be stored on the floor head mount (17, fig D).
Use
Switching on and o (fig. D)
•To switch the appliance on, press the on/o switch (5).
•To switch the appliance off, press the on/o switch (5).
Variable power control (fig. D)
The variable power control allows you to select the required suction force for job to be performed.
•Slide the variable power control (7) left and right to the requried setting.
Select minimum suction power for delicate materials.
Select medium suction power for mattresses, upholstered furniture and carpets.
Select maximum suction power for tiled, wood and other hard floors.
Vacuuming
•When operating the appliance, make sure that the hose is not trapped, twisted or blocked.
7