Bosch Appliances 1594 manual Maintenance, Accessories, Tool Lubrication, Carbon Brushes, Bearings

! WARNING

! CAUTION

! WARNING

Maintenance

Service

Preventive maintenance

!WARNING performed by unauthorized personnel may result in misplacing of internal wires and components which could cause serious hazard. We recommend that all tool service be performed by a Bosch Factory Service Center or Autho- rized Bosch Service Station.

TOOL LUBRICATION

Your Bosch tool has been properly lubricated and is ready to use. It is recommended that tools with gears be regreased with a special gear lubricant at every brush change.

CARBON BRUSHES

The brushes and commutator in your tool have been engineered for many hours of dependable service. To maintain peak efficiency of the motor, we recommend every two to six months the brushes be examined. Only genuine Bosch replacement brushes specially designed for your tool should be used.

BEARINGS

After about 300-400 hours of operation, or at every second brush change, the bearings should be replaced at Bosch Factory Service

Center or Authorized Bosch Service Station. Bearings which become noisy (due to heavy load or very abrasive material cutting) should be replaced at once to avoid overheating or motor failure.

Cleaning

To avoid accidents always disconnect the tool from the power supply before cleaning or

performing any maintenance. The tool may be cleaned most effectively with compressed dry air. Always wear safety goggles when cleaning tools with compressed air.

Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not attempt to clean by inserting pointed objects through openings.

Certain cleaning agents and solvents damage plastic parts. Some of these are: gasoline,

carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia.

Clean the park rest shoe regularly and ensure that it springs back freely.

Accessories

If an extension cord is necessary, a cord with adequate size conductors that is capable

of carrying the current necessary for your tool must be used. This will prevent excessive voltage drop, loss of power or overheating. Grounded tools must use 3-wire extension cords that have 3-prong plugs and receptacles.

NOTE: The smaller the gauge number, the heavier the cord.

Woodrazor reversible micro grain

TC blades (2) *

T-30 Torx blade wrench *

Deluxe Bevel Guide Fence *

Vacuum hose adapter **

Straight Guide Fence **

Rabbeting depth stop **

Chip bag *

RECOMMENDED SIZES OF EXTENSION CORDS

120 VOLT ALTERNATING CURRENT TOOLS

						Wire Sizes in mm2
		Cord Size in A.W.G.
Tool’s
Ampere
		Cord Length in Feet				Cord Length in Meters
Rating
		25	50	100	150	15	30	60	120
	18		16	16	14	0.75	0.75	1.5	2.5
3-6
6-8	18		16	14	12	0.75	1.0	2.5	4.0
8-10	18		16	14	12	0.75	1.0	2.5	4.0
10-12	16		16	14	12	1.0	2.5	4.0	—
12-16	14		12	—	—	—	—	—	—

High-Speed Steel Blades ** HSS Blade Leveling Fixture **

High-Speed Steel Blades with Retainers **

(*= standard equipment) (**= optional accessories)

-14-