Desa GVR65BPA, GVR65PA, GVR50PA, GVR35PA, GVR50BPA installation manual Installing Heater

Page 7

INSTALLING HEATER

Continued

LOCATING HEATER

WARNING

WARNING ICON

G 001

Maintain the minimum clearances shown in Figure 3, below. If you can, provide greater clearances.

WARNING

WARNING ICON

G 001

Never install the heater

•in a mobile home or a recreational vehicle.

•where curtains, furniture, clothing, or other flam- mable objects are less than 48 inches from the front, 53 inches from the top, 12 inches from the right side and 6 inches from the left side and back of heater.

•directly on carpeting, tile, or other combustible materials other than wood flooring. Place heater on metal or wood panel extending the full width and depth of heater.

•as a fireplace insert.

•in high traffic areas.

•in windy or drafty areas.

CAUTION

WARNING ICON

G 001

If you install the heater in a home garage

•heater pilot and burner must be at least 18 inches above floor

•locate heater where moving vehicle will not hit it.

For convenience and efficiency, install heater

•where there is easy access for operation, inspection, and service.

•in coldest part of room.

•near an electrical outlet if heater has blower or if you are planning to add blower to heater. See Accessories, page 37 for blower.

	CEILING
6"
Minimum	53"
	Minimum

Left	Right
Left	Side
Side	Side
Side
		6" Minimum
		from Back
		12"
	48" Minimum from	Minimum
	48" Minimum from
	Front of Heater	Continued
	Figure 3 - Heater Clearances	Continued
	Figure 3 - Heater Clearances

100791

7

Image 7

Contents For Your Safety OWNER’S Operation and Installation ManualWhat to do if YOU Smell GAS Contents Safety Information Safety Information Identification ProductUnpacking FeaturesInstalling Heater Local CodesInstalling Heater Venting Heater Do not vent heater in any of the following ways see Figure Venting HeaterVenting Heater Proper Size Vent Qualified service person must connect heater to gas Connecting to GAS SupplySupply. Follow all local codes Gas Connection Checking GAS Connections Pressure Testing Gas Supply Piping SystemLocation of Radiants Installing RadiantsFor Radiant Models Only Installing Glass PanelInserting Glass into Lower Retaining Channel AIR for Combustion and Ventilation Draft Hood Spillage Test AIR forVentilation Determining FRESH-AIR Flow for Heater LocationLeases poisonous carbon monoxide gas into your home 18 to make sure fresh air ventilation is adequate Confined area has an air volume of less than 50 cubicOperating Heater For Your Safety Read Before LightingViewing Pilot Shutting Off Heater Manual Lighting ProcedureBlower Operation To Turn OFF GAS to AppliancePilot Flame Pattern Inspecting Pilot and Burner FlameBurner Flame Pattern Flame Maintenance CleaningObserved Possible Problem Cause Remedy Trouble ShootingTROUBLE- Shooting Cleaning and MainteSee Changing Burner Orifice, Lighting Instructions Top Ing statement atRemoving Control Valve and Burner Tube Service ProceduresRemoving Burner Changing Burner Orifice WiringDiagram BlowerModel Technical ServiceService Hints 35,000 BTU/Hr 50,000 BTU/HrParts Ordering ReplacementParts Under Warranty Parts Not Under WarrantyBlower KIT Part Number GA6010 AccessoriesBlower Assembly Illustrated Parts ListIllustrated Parts List Cabinet Assembly for Radiant Models Burner Assembly for Radiant Models Parts List Burner Assembly for Radiant Models 100791 100791 Limited Warranty GVR/GVC Vented Propane GAS Heaters Warranty Information