Electrolux Over The Range Microwave Oven Aligning the Wall Plate, Horizontal Line

Page 10

Installation Instructions

D.ALIGNING THE WALL PLATE

Hole A	Centerline
	notches

Horizontal Line

Area E

Draw a Vertical Line on Wall from Center of Top Cabinet

C

L

Hole C

Hole B Horizontal Line

CAUTION: Wear gloves to avoid cutting fingers on sharp edges.

1. Draw a Vertical line on the wall at the center of the 30" wide space.

2. Draw a Horizontal line on the wall at the bottom of “Rear Wall Template”.

3. Drill 5/8" holes for toggle bolts on 3 locations (Hole A, Hole B, Hole C) but if the location of hole is same as that of stud, drill a 3/16" hole for wood screw. In other words, toggle bolt can not be used to the location of stud.

NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.

Draw a Horizontal line on wall from bottom of “Rear Wall Template”.

NOTE: Holes A, B and C are inside area E. If none of A, B and C is in a stud, find a stud somewhere in area E and draw a forth circle to line up with the stud. It is important to use at least one wood screw mounted firmly in a stud to support the weight of the microwave. Set the mounting plate aside.

10

Image 10

Contents Installation Instructions Before YOU BeginContents Important Safety Instructions Electrical RequirementsOutside Back Exhaust Example only Hood ExhaustOutside TOP Exhaust Example only Duct Pieces Equivalent Number Length UsedMaximum duct length Exhaust connectionHardware Packet Damage SHIPMENT/ InstallationParts Included Additional PartsTools YOU will Need Mounting SpaceFinding the Wall Studs Placement of the Mounting PlateMicrowave Must be Connected to AT Least ONE Wall Stud Determining Wall Plate Location Under Your Cabinet Microwave Must be LevelHorizontal Line Aligning the Wall PlateHole B Horizontal Line Outside Back Exhaust Horizontal Duct Recirculating NON-VENTED DuctlessOutside TOP Exhaust Vertical Duct SeeA1. Attach the Mounting Plate to the Wall To use toggle boltsInstall this Microwave Oven A3. Mount the Microwave OvenTo the Wall Installation OverviewB1. Attach the Mounting Plate To help tighten the boltsRemove and save Lift up Screw that holds B3. Adapting Microwave Blower for Outside TOP ExhaustBlower plate to Microwave B5. Mount the Microwave Oven Onto four lower tabs of mounting plateB5. Mount the Microwave Oven B6. Adjust the Exhaust AdaptorB7. Connecting Ductwork Attach the microwave oven to the top cabinetFor Outside Back Exhaust C1. Preparing the Rear WallPlate to a wall stud C3. USE TOP Cabinet Template C2. Attach the Mounting PlateTo the Wall For Preparation of TOP CabinetPlace the blower unit back into the opening C5. Mount the Microwave OvenSecure the blower unit to the microwave with the screw C5. Mount the Microwave Oven Before YOU USE Your Microwave