Electrolux Over The Range Microwave Oven Installation Overview, B1. Attach the Mounting Plate

Page 14

Installation Instructions

B.OUTSIDE TOP EXHAUST (Vertical Duct)

INSTALLATION OVERVIEW
B1.	Attach Mounting Plate to Wall
B2.	Prepare Top Cabinet
B3.	Adjust Blower
B4.	Check Damper Operation
B5.	Mount Microwave Oven
B6.	Adjust Exhaust Adaptor
B7.	Connect Ductwork
B1. ATTACH THE MOUNTING PLATE		To use toggle bolts:

TO THE WALL

Spacing for Toggles More

Than Wall Thickness


							Toggle Wings
							Toggle Wings
Mounting								Toggle
Mounting								Toggle
Plate								Bolt

	Wall
	Bolt End
Attach the plate to the wall using toggle bolts. At least	3. Place the mounting plate against the wall and
one wood screw must be used to attach	insert the toggle wings into the holes in the wall to
the plate to a wall stud.	mount the plate.
1. Remove the toggle wings from the bolts.	NOTE: Before tightening toggle bolts and wood
2. Insert the bolts into the mounting plate through the	screw, make sure to coincide bottom line of the
2. Insert the bolts into the mounting plate through the	Mounting plate with Horizontal line of “Rear wall
holes designated to go into drywall and reattach	Template” and then the Mounting plate is properly
the toggle wings to ¾" onto each bolt.	centered under the cabinet.
	CAUTION: Be careful to avoid pinching fingers
	between the back of the mounting plate and the wall.
	4. Tighten all bolts. Pull the plate away from the wall
	to help tighten the bolts.

14

Image 14

Contents Installation Instructions Before YOU BeginContents Important Safety Instructions Electrical RequirementsOutside Back Exhaust Example only Hood ExhaustOutside TOP Exhaust Example only Duct Pieces Equivalent Number Length UsedMaximum duct length Exhaust connectionHardware Packet Damage SHIPMENT/ InstallationParts Included Additional PartsTools YOU will Need Mounting SpaceMicrowave Must be Connected to AT Least ONE Wall Stud Placement of the Mounting PlateFinding the Wall Studs Determining Wall Plate Location Under Your Cabinet Microwave Must be LevelHole B Horizontal Line Aligning the Wall PlateHorizontal Line Outside Back Exhaust Horizontal Duct Recirculating NON-VENTED DuctlessOutside TOP Exhaust Vertical Duct SeeA1. Attach the Mounting Plate to the Wall To use toggle boltsInstall this Microwave Oven A3. Mount the Microwave OvenTo the Wall Installation OverviewB1. Attach the Mounting Plate To help tighten the boltsBlower plate to Microwave B3. Adapting Microwave Blower for Outside TOP ExhaustRemove and save Lift up Screw that holds B5. Mount the Microwave Oven Onto four lower tabs of mounting plateB5. Mount the Microwave Oven B6. Adjust the Exhaust AdaptorB7. Connecting Ductwork Attach the microwave oven to the top cabinetPlate to a wall stud C1. Preparing the Rear WallFor Outside Back Exhaust C3. USE TOP Cabinet Template C2. Attach the Mounting PlateTo the Wall For Preparation of TOP CabinetSecure the blower unit to the microwave with the screw C5. Mount the Microwave OvenPlace the blower unit back into the opening C5. Mount the Microwave Oven Before YOU USE Your Microwave