Electrolux Over The Range Microwave Oven installation instructions A3. Mount the Microwave Oven

Page 13

Installation Instructions

A3. MOUNT THE MICROWAVE OVEN

FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE

INSTALL THIS MICROWAVE OVEN.

IMPORTANT: Do not grip or use handle during installation.

NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.

NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws.

NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1–3. Do not pinch cord or lift oven by pulling cord.

1. Lift microwave, tilt it forward, and hook slots at back bottom edge

onto four lower tabs of mounting plate.

2. Rotate front of oven up against cabinet bottom

3. Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely

tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord,

especially when mounting flush to bottom of cabinet.

Cabinet Front

Cabinet Bottom Shelf

Filler Block

Equivalent to

Depth of

Cabinet Recess

Self-Aligning Screw

Microwave Oven Top

4. Attach the microwave oven to the top cabinet.

5. Insert 2 self-aligning screws through outer top cabinet holes. Turn two full turns on each screw.

6. Tighten center screw completely.

7. Tighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.)

8. Install grease filters. See the Owner’s Manual packed with the microwave.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Before YOU Begin Installation InstructionsContents Electrical Requirements Important Safety InstructionsOutside TOP Exhaust Example only Hood ExhaustOutside Back Exhaust Example only Duct Pieces Equivalent Number Length UsedExhaust connection Maximum duct lengthParts Included Damage SHIPMENT/ InstallationHardware Packet Additional PartsMounting Space Tools YOU will NeedFinding the Wall Studs Placement of the Mounting PlateMicrowave Must be Connected to AT Least ONE Wall Stud Microwave Must be Level Determining Wall Plate Location Under Your CabinetHorizontal Line Aligning the Wall PlateHole B Horizontal Line Outside TOP Exhaust Vertical Duct Recirculating NON-VENTED DuctlessOutside Back Exhaust Horizontal Duct SeeTo use toggle bolts A1. Attach the Mounting Plate to the WallA3. Mount the Microwave Oven Install this Microwave OvenB1. Attach the Mounting Plate Installation OverviewTo the Wall To help tighten the boltsRemove and save Lift up Screw that holds B3. Adapting Microwave Blower for Outside TOP ExhaustBlower plate to Microwave Onto four lower tabs of mounting plate B5. Mount the Microwave OvenB7. Connecting Ductwork B6. Adjust the Exhaust AdaptorB5. Mount the Microwave Oven Attach the microwave oven to the top cabinetFor Outside Back Exhaust C1. Preparing the Rear WallPlate to a wall stud To the Wall C2. Attach the Mounting PlateC3. USE TOP Cabinet Template For Preparation of TOP CabinetPlace the blower unit back into the opening C5. Mount the Microwave OvenSecure the blower unit to the microwave with the screw C5. Mount the Microwave Oven Before YOU USE Your Microwave
Top Page Image Contents