Electrolux Over The Range Microwave Oven B3. Adapting Microwave Blower for Outside TOP Exhaust

Page 15

Installation Instructions

B2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET

You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor.

•Read the instructions on the TOP CABINET TEMPLATE.

•Tape it underneath the top cabinet.

•Drill the holes, following the instructions on the

TOP CABINET TEMPLATE.

CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.

B3. ADAPTING MICROWAVE BLOWER FOR OUTSIDE TOP EXHAUST

1. Remove and save

2. Lift up the

screw that holds

blower plate.

blower plate to

 

microwave.

 

Blower Plate

Back of

Microwave

Screw

3. Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.

CAUTION: Do not touch blade of blower to prevent cracking and breaking. Hold outer case when the blower is removed and re-installed.

4. Roll the blower unit 90° so that fan blade openings are facing toward the top of the microwave.

BEFORE: Fan Blade

Openings Facing Forward

Roll

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Before YOU Begin Installation InstructionsContents Electrical Requirements Important Safety InstructionsDuct Pieces Equivalent Number Length Used Hood ExhaustOutside TOP Exhaust Example only Outside Back Exhaust Example onlyExhaust connection Maximum duct lengthAdditional Parts Damage SHIPMENT/ InstallationParts Included Hardware PacketMounting Space Tools YOU will NeedPlacement of the Mounting Plate Finding the Wall StudsMicrowave Must be Connected to AT Least ONE Wall Stud Microwave Must be Level Determining Wall Plate Location Under Your CabinetAligning the Wall Plate Horizontal LineHole B Horizontal Line See Recirculating NON-VENTED DuctlessOutside TOP Exhaust Vertical Duct Outside Back Exhaust Horizontal DuctTo use toggle bolts A1. Attach the Mounting Plate to the WallA3. Mount the Microwave Oven Install this Microwave OvenTo help tighten the bolts Installation OverviewB1. Attach the Mounting Plate To the WallB3. Adapting Microwave Blower for Outside TOP Exhaust Remove and save Lift up Screw that holdsBlower plate to Microwave Onto four lower tabs of mounting plate B5. Mount the Microwave OvenAttach the microwave oven to the top cabinet B6. Adjust the Exhaust AdaptorB7. Connecting Ductwork B5. Mount the Microwave OvenC1. Preparing the Rear Wall For Outside Back ExhaustPlate to a wall stud For Preparation of TOP Cabinet C2. Attach the Mounting PlateTo the Wall C3. USE TOP Cabinet TemplateC5. Mount the Microwave Oven Place the blower unit back into the openingSecure the blower unit to the microwave with the screw C5. Mount the Microwave Oven Before YOU USE Your Microwave
Top Page Image Contents