Electrolux Over The Range Microwave Oven Tools YOU will Need, Mounting Space

Page 7

Installation Instructions

TOOLS YOU WILL NEED

		Ruler or tape measure
		and straight edge	Carpenter square
# 1 and #2 Phillips screwdriver	Pencil		(optional)
# 1 and #2 Phillips screwdriver	Pencil

	Tin snips (for cutting	Scissors	Electric drill with 3/16", ½"
	damper, if required)
		(to cut template, if necessary)	and 5/8" drill bits

Gloves

Saw (saber, hole or keyhole)

Stud finder or Hammer (optional)

Filler blocks or scrap wood pieces, if needed for top cabinet spacing (used on recessed bottom cabinet installations only)

Safety goggles

Level

Duct and masking tape

MOUNTING SPACE

	Bottom edge of
	cabinet needs
	to be 33" or
16-½ "	more from the
16-½ "	cooking
	surface
	33"min.
	5"
	Backsplash

NOTES:

•The space between the cabinets must be 30" wide and free of obstructions.

•This microwave oven should be mounted minimum of 33" above cooking service.

•If you are going to vent your microwave oven to the outside, see Hood Exhaust Section for exhaust duct preparation.

•When installing the microwave oven beneath smooth flat cabinets be careful to follow the instructions on the top cabinet template for power cord clearance.

7

Image 7

Contents Before YOU Begin Installation InstructionsContents Electrical Requirements Important Safety InstructionsDuct Pieces Equivalent Number Length Used Hood ExhaustOutside TOP Exhaust Example only Outside Back Exhaust Example onlyExhaust connection Maximum duct lengthAdditional Parts Damage SHIPMENT/ InstallationParts Included Hardware PacketMounting Space Tools YOU will NeedFinding the Wall Studs Placement of the Mounting PlateMicrowave Must be Connected to AT Least ONE Wall Stud Microwave Must be Level Determining Wall Plate Location Under Your CabinetHorizontal Line Aligning the Wall PlateHole B Horizontal Line See Recirculating NON-VENTED DuctlessOutside TOP Exhaust Vertical Duct Outside Back Exhaust Horizontal DuctTo use toggle bolts A1. Attach the Mounting Plate to the WallA3. Mount the Microwave Oven Install this Microwave OvenTo help tighten the bolts Installation OverviewB1. Attach the Mounting Plate To the WallRemove and save Lift up Screw that holds B3. Adapting Microwave Blower for Outside TOP ExhaustBlower plate to Microwave Onto four lower tabs of mounting plate B5. Mount the Microwave OvenAttach the microwave oven to the top cabinet B6. Adjust the Exhaust AdaptorB7. Connecting Ductwork B5. Mount the Microwave OvenFor Outside Back Exhaust C1. Preparing the Rear WallPlate to a wall stud For Preparation of TOP Cabinet C2. Attach the Mounting PlateTo the Wall C3. USE TOP Cabinet TemplatePlace the blower unit back into the opening C5. Mount the Microwave OvenSecure the blower unit to the microwave with the screw C5. Mount the Microwave Oven Before YOU USE Your Microwave