Electrolux Over The Range Microwave Oven Recirculating NON-VENTED Ductless, See

Page 11

Installation Instructions

2. INSTALLATION TYPES (Choose A, B or C)

This microwave oven is designed for adaptation to the following three types of ventilation:

A.Recirculating (Non-Vented Ductless)

B.Outside Top Exhaust (Vertical Duct)

C.Outside Back Exhaust (Horizontal Duct)

NOTE: This microwave is shipped after being assembled for “Recirculating”. And exhaust adaptor is shipped assembled to the filler-upper. Select the type of ventilation required for your installation and proceed to that section.

A.RECIRCULATING (NON-VENTED DUCTLESS)

See page 12

B.OUTSIDE TOP EXHAUST (VERTICAL DUCT)

Adaptor in Place for

Outside Top

Exhaust

See page 14

C.OUTSIDE BACK EXHAUST (HORIZONTAL DUCT)

See page 18

Image 11

Contents Before YOU Begin Installation InstructionsContents Electrical Requirements Important Safety InstructionsDuct Pieces Equivalent Number Length Used Hood ExhaustOutside TOP Exhaust Example only Outside Back Exhaust Example onlyExhaust connection Maximum duct lengthAdditional Parts Damage SHIPMENT/ InstallationParts Included Hardware PacketMounting Space Tools YOU will NeedMicrowave Must be Connected to AT Least ONE Wall Stud Placement of the Mounting PlateFinding the Wall Studs Microwave Must be Level Determining Wall Plate Location Under Your CabinetHole B Horizontal Line Aligning the Wall PlateHorizontal Line See Recirculating NON-VENTED DuctlessOutside TOP Exhaust Vertical Duct Outside Back Exhaust Horizontal DuctTo use toggle bolts A1. Attach the Mounting Plate to the WallA3. Mount the Microwave Oven Install this Microwave OvenTo help tighten the bolts Installation OverviewB1. Attach the Mounting Plate To the WallBlower plate to Microwave B3. Adapting Microwave Blower for Outside TOP ExhaustRemove and save Lift up Screw that holds Onto four lower tabs of mounting plate B5. Mount the Microwave OvenAttach the microwave oven to the top cabinet B6. Adjust the Exhaust AdaptorB7. Connecting Ductwork B5. Mount the Microwave OvenPlate to a wall stud C1. Preparing the Rear WallFor Outside Back Exhaust For Preparation of TOP Cabinet C2. Attach the Mounting PlateTo the Wall C3. USE TOP Cabinet TemplateSecure the blower unit to the microwave with the screw C5. Mount the Microwave OvenPlace the blower unit back into the opening C5. Mount the Microwave Oven Before YOU USE Your Microwave