Electrolux EBGL70 user manual Installing the Oven Under a Work Surface, Electrical Connection, Min

Page 28

28 www.electrolux.com

A

2.Use a minimum of 2 screws to attach the appliance on the 2 sides (Detail A).

INSTALLING THE OVEN UNDER A WORK SURFACE

Before the installation, connect the oven to the electrical supply. Refer to "Electrical connection".

			B
	180		ca.50
A	A		N 600
			A 595
			442
	115
	N min. 550
	A 567
	20
	N 560-568
	A 592
	A	B	min. 20
	A	B
			15
		20	A
			A

A = appliance

N = recess

WARNING!

Installation into flammable material must agree with NIN SEV 1000 (Association of Cantonal Fire Insur- ers) fire protection guidelines and regulations.

CAUTION!

Make sure the cable is free when you move the appliance.

1.Push the cooker into the recess so that it is flush with the surrounding units.

2.Use at least 2 screws to fix the appli- ance on both sides (Detail A).

WARNING!

When installing next to a wood-fu- elled boiler, a heatproof and heat- insulating plate must be mounted at the height of the appliance and at least 30 cm deep.

ELECTRICAL CONNECTION

Use a power cable of H05VV-F or higher. Connect the appliance to a socket supply line. If there is no socket supply line, the electrical installation must have an isolation device which lets you disconnect the appli- ance from the power supply. The isolation

device must have a contact opening width of minimum 3 mm (in reference to NIN SEV 1000). The customer must have a socket for the electrical connection that is accessi- ble and outside the coordination room. The length of the connection cable must be ap- proximately 120 cm with lines connected directly to the power supply.

Image 28

Contents EBGL70 EN Oven Customer Care and Service ContentsWE’RE Thinking of YOU Safety Information InstallationElectrical connection Risk of suffocation, injury or perma- nent disabilityCare and Cleaning USESteam Cooking Internal LightDisposal Accessories Wire shelfProduct Description Baking trayCore temperature sensor To measure how far the food is cookedInitial Cleaning Preheating First Setting the Time DAYBefore First USE First Connection to MainsElectronic Programmer Control PanelFunction Description Field Other Indicators of Display HEAT-UP IndicatorYou can examine or change the temperature DisplayDaily USE Heating function ApplicationSetting the Heating Function Changing TemperatureChecking the Temperature Fast Heat UP FunctionEnglish Count UP Timer Setting the DurationSetting the END Setting the Minute MinderSetting the Time Delay Function Automatic Programmes With Weight Input Setting an automatic recipeAutomatic Programmes Automatic RecipesUsing the Accessories Core Temperature SensorThere are two temperatures to set You can set the core temperatureInserting the Accessories Touch again and again to see three other temperaturesAll accessories have small indentations To increase safety. Always make sureEnglish Settings Menu Additional FunctionsMY Favourite Programme Function Control LockAutomatic SWITCH-OFF Oven temperature Switch-off timeBrightness of the Display Cooling FANCare and Cleaning Steam CleaningShelf Supports Removing the shelf supportInstalling the shelf supports Cleaning the DoorCleaning the water drawer and the steam generator Steam Generation SystemLamp Problem Possible cause Solution What to do IF…Serial number S.N Installation Installing the OvenTo lift the appliance, do not use the door handle = appliance = recessElectrical Connection Installing the Oven Under a Work SurfaceMin Connection Diagram 400 Electrical Connection with the HOBCH GARANTIE, GARANZIA, Guarantee Servicestellen Points de Service Servizio dopo VenditaEnvironment Concerns 892934989-B-482011