OPERATING YOUR BREVILLE Deep fryer
1.Place the deep fryer on a flat, dry surface. Ensure the deep fryer is not too close to the edge of the counter, and that the power cord or basket handle does not extend over the edge.
2.Remove the lid and frying basket from the deep fryer.
3.Fill the deep fryer with cooking oil between the 'MAX' and 'MIN' levels shown on the heater tube. From empty, the maximum level is approximately 3.4 quarts (3.2 liters), and the minimum level is approximately 3 quarts (2.8 liters). Use only good quality fresh cooking oil with a high smoke point. DO NOT OVER OR UNDERFILL.
NOTE:
The deep fryer should be connected to a power supply only after it has been filled with oil.
4.Attach the magnetic cord assembly into the rear of the deep fryer first, then plug the cord into a 120V power outlet. When properly aligned, the plug will magnetically attach itself to the control panel housing. If positioned upside down, it will not attach.
NOTE:
The magnetic cord is designed to detach easily from the fryer in case a child accidentally pulls on the cord. As a result, if it is bumped or touched during use, it could accidentally detach during operation. If contact with the cord occurs during operation, check that it is still properly connected to the fryer.
5.Turn the 'ON/OFF' switch at the rear of the control panel to the 'I' (On) position. The 'Power' indicator light will illuminate. It will stay lit until either the switch is turned to the 'O' (Off) position, or power is disconnected from the deep fryer.
NOTE:
Do not turn the unit on without oil in the oil vessel.
6.Turn the temperature dial to the required setting for the food being fried. Most commercial deep frying is carried out at approximately 375°F. This is the maximum temperature position on the temperature dial. Small volumes and light foods can be successfully deep fried at lower temperatures, although generally, around 320°F is regarded as
a practical minimum temperature for healthy frying.
7.When the 'ON/OFF' switch at the rear of the control panel is turned to the 'I' (On) position, the orange 'HEATING' light will illuminate, indicating that the oil is heating to the selected temperature on the temperature dial. Once the selected temperature is reached, the 'HEATING' light will go out, however will cycle on and off during operation to maintain the correct temperature.
14
BDF600XL_IB_H10.indd 14 | 6/05/10 11:20 AM |