5.Using an adjustable wrench, hold the nut on the plastic water line to keep it from moving. Then, with a second wrench turn the compression nut on the copper tubing counterclockwise to completely tighten. Do not overtighten.
| A |
| B |
| C |
| D |
| E |
A. Plastic water line | D. Copper tubing |
B. Water valve inlet port | E. “P” clamp |
C. Compression nut |
|
6.Check connection by pulling on copper tubing. Attach copper tubing to refrigerator cabinet with a “P” clamp. Turn on water supply to refrigerator and check for leaks. Correct any leaks.
Complete the Installation
Base Grille
Remove the Base Grille
1.Grasp the grille with both hands.
2.Pull the grille toward you.
Replace the Base Grille
1.See the markings on the inside of the base grille for proper placement.
2.Align the grille mounting clips with the cabinet slots.
3.Push the grille firmly into the cabinet slots until it snaps into place.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
1.Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill the ice container.
Refrigerator Door
Graphics are included later in this section.
Remove and Replace Handles (Architect® Series)
1.Using a ³⁄₃₂" Allen wrench, loosen the two set screws located on the side of each handle. See Graphics 2 and 4.
2.Pull the handle straight out from the door. Make sure you keep the screws for reattaching handles.
3.To replace the handle, reverse the directions.
Remove Handles (Panel Series)
IMPORTANT:
■Remove the door from refrigerator before removing handles.
■You must remove the handles to remove the decorator panels or to reverse the door swing.
1.Using a Phillips screwdriver, remove the top door cap. See Graphic 3.
2.Tap the bottom edge of the refrigerator door handle upward with a rubber mallet.
3.Handle will slide up approximately ³⁄₄" (19.05 mm) and release from the door.
7