KitchenAid 2266877 manual Installation Instructions, Unpack Refrigerator, Reduce Tipping Radius

Page 13

INSTALLATION

INSTRUCTIONS

Unpack Refrigerator

WARNING

Tip Over Hazard

Refrigerator is top heavy and tips easily when not completely installed.

Keep doors taped closed until refrigerator is completely installed.

Use two or more people to move and install refrigerator.

Failure to do so can result in death or serious injury.

IMPORTANT:

■Do not lower the refrigerator against the shipping base when removing the shipping base.

■Do not remove protective film until refrigerator is in operating position.

■All four leveling legs must contact the floor to support and stabilize the full weight of the refrigerator.

■Keep cardboard shipping piece or plywood under refrigerator until it is installed in the operating position.

1.Remove and save literature package and parts bag taped to refrigerator door. Remove four brackets (two on each side) attaching shipping base to refrigerator bottom.

NOTE: Do not remove tape and door bracing until refrigerator is in final position.

2.Place appliance dolly under the freezer side of the refrigerator. Pass the dolly strap under the handles then loosely wrap dolly strap around refrigerator. Insert carton

corner posts between strap and side trim. Carefully tighten strap, making sure side trim is protected.

1

1

2

1.Corner posts over side trim

2.Corner posts over handle

3.Place pieces of shipping carton on the floor when rolling the dolly and refrigerator into the house. Move refrigerator close to built-in opening.

Reduce Tipping Radius

(if required)

If you do not have adequate ceiling height to stand refrigerator upright, the tipping radius can be reduced by removing the top grille and side trims (see the following chart).

Model

Reduced Tipping Radius

 

 

36 in. (91.4 cm)

88 in. (223.5 cm)

42 in. (106.7 cm)

88¹⁄₂ in. (224.8 cm)

48 in. (121.9 cm)

89¹⁄₄ in. (226.7 cm)

 

 

NOTE: To avoid hitting the compressor housing on the ceiling, the refrigerator must be raised up by first placing the left bottom edge of the refrigerator on floor, standing the refrigerator upright, and then lowering the right side of the refrigerator down to the floor.

Panel Models

1.Grasp both ends of top grille assembly.

2.Push top grille assembly straight up, then pull straight out. Lay grille assembly on a soft surface.

2

1

2

1.Top grille

2.Cabinet side trim

3.Remove the 6 screws attaching each cabinet side trim to the refrigerator and remove the side trims.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Guide D’INSTALLATION Installation GuideManual DE Instalación Built-In RefrigeratorsSide bySide and Bottom MountÍndice Table of ContentsTable DES Matières Your safety and the safety of others are very important Refrigerator SafetyTools and Parts Product DimensionsSide View All models Top View All modelsWidth of Refrigerator Model Width a as shown above Opening DimensionsLocation Preparation Location RequirementsWidth of Opening Model Width a as shown above Water Supply Requirements Electrical RequirementsTipping Radius Side Tipping Radius see chart following Door Swing DimensionsSide by Side Door Swing Dimensions Bottom Mount Models Door Swing DimensionsFactory Panels and Kits Door Panels for Non-dispenser Models Custom Top Grille and Door PanelsDoor Panels for Dispenser Models Routing for Custom Top Grille and Door Panels all models Refrigerator and Freezer Door PanelsTop Grille Panel Routing Door Panel RoutingCustom Side Panels End View of Side Trim Dimensions Inset Side PanelSide by Side and Bottom Mount Side Panels Flush Side PanelUnpack Refrigerator Installation InstructionsReduce Tipping Radius Model Reduced Tipping RadiusInstall New Water Line Install Anti-Tip BoardsTo install anti-tip boards Wraparound modelsStyle 2 Connecting to a Water Valve Style 1 Connecting to a Water LineWater System Connection Plug in RefrigeratorMove Refrigerator to Final Position Install Door PanelsLower Leveling Legs Level RefrigeratorDoor Height Adjustment Adjust DoorsDoor Alignment Door Swing Adjustment Install Decorative Top PanelAdding a Decorative Panel to the Top Grille Assembly Install Base Grille Install Side PanelComplete Installation Su seguridad y la seguridad de los demá s es muy importante Seguridad DEL RefrigeradorPiezas y herramientas Medidas del productoVista lateral Todos los modelos Herramientas requeridasVista frontal para los modelos de dos puertas Vista superior Todos los modelosVista delantera para los modelos de montaje inferior Medidas de aberturaCm mín Requisitos de ubicaciónRequisitos de suministro de agua Requisitos eléctricosMétodo de conexión a tierra recomendado Suministro de agua fríaMedidas de oscilación de las puertas Arco de vuelcoMedidas de oscilación de dos puertas Arco de vuelco hacia adelante igual para todos los modelosMedidas de oscilación de las puertas de montaje inferior Paneles y juegos de fábricaJuegos de paneles y agarraderas de dos puertas Juegos de paneles para puertas de fábricaJuego para rejilla superior Paneles a la medida para la rejilla Superior y las puertasJuego para rejilla superior de modelos con panel Juego de rejilla superior para modelos envolventesPaneles de puerta para modelos con despachador Paneles de puerta para modelos sin despachadorPaneles de puertas de refrigerador y congelador Contorneado del panel de la rejilla superiorContorneado del panel de la puerta Paneles laterales a la medidaPaneles laterales de dos puertas y de montaje inferior Medidas del adorno lateral visto desde atrásCómo desempacar su refrigerador Instrucciones DE InstalaciónPanel lateral en relieve Panel lateral al rasCómo instalar los tableros anti-vuelco Cómo reducir el arco de vuelcoModelo Arco de vuelco reducido Modelos con panelesCómo conectar el sistema de agua Instalación de una tubería de agua NuevaCómo instalar los tableros antivuelco Ubicación final del refrigerador Cómo enchufar el refrigeradorEstilo 2 Conexión a una válvula de agua Cómo instalar los paneles de la puerta Patas niveladoras inferioresCómo nivelar el refrigerador Modelos con panelCómo alinear las puertas Cómo ajustar las puertasCómo ajustar la altura de la puerta Cómo ajustar la oscilación de las puertas Cómo instalar el panel decorativo SuperiorCómo instalar la rejilla de la base Cómo instalar el panel lateralCómo terminar la instalación Votre sé curité et celle des autres est trè s importante Sécurité DU RéfrigérateurDimensions du produit Exigences ’INSTALLATIONOutillage et pièces nécessaires Vue latérale Tous les modèlesPréparation de lemplacement Dimensions de l’ouvertureVue de dessus Tous les modèles Vue avant pour les modèles côte à côteRisque dexplosion Exigences d’emplacementSpécifications de l’alimentation en eau Spécifications électriquesRayon de basculement Rayon de basculement latéral voir le tableau suivant Dimensions pour le pivotement Des portesModèles de 42 po 106 cm Modèles de 48 po 122 cmEnsembles de panneaux de porte dorigine Ensembles de panneaux dorigineEnsembles de poignées de porte prolongées Ensemble de la grille supérieurePanneaux de porte pour modèles sans distributeur Panneaux personnalisés de la grille Supérieure et de portePanneaux de porte pour modèles avec distributeur Couleur Ouverture vers Ouverture vers la La gauche DroiteUsinage du panneau de la grille supérieure Panneaux de porte de réfrigérateur et de congélateurUsinage du panneau de porte Panneaux latéraux personnalisés Dimensions pour lusinage du panneau de porte vue latéralePanneau latéral inséré Panneau latéral en affleurementDéballage du réfrigérateur Instructions ’INSTALLATIONRéduction du rayon de basculement Panneau latéral inséré en retraitInstallation des planches antibasculement Installation de planches Anti-basculementModèles à panneaux Modèles à portes enveloppantesRaccordement de la canalisation d’eau Installation d’une nouvelle Canalisation d’eauStyle 2 Raccordement au robinet deau Installation des panneaux de porte Déplacement du réfrigérateur à Lemplacement finalBrancher le réfrigérateur Déploiement des pieds de nivellementAjustement des portes Nivellement du réfrigérateurAlignement des portes Réfrigérateurs côte à côteAjustement de l’ouverture des portes Ajustement de la hauteur des portesRéfrigérateurs superposés Installation du panneau latéral Installation du panneau décoratif SupérieurAddition dun panneau décoratif à la grille supérieure Achever l’installation Installation de la grille de la baseAll rights reserved 2266877

2266877 specifications

The KitchenAid 2266877 is an essential kitchen appliance that epitomizes convenience, durability, and style. As part of KitchenAid’s renowned lineup, this model is designed to cater to both amateur cooks and seasoned chefs. One of its standout features is the robust motor that ensures efficient mixing and kneading, while maintaining a quiet operation. This powerful motor is complemented by a range of speed settings, allowing users to choose the perfect speed for various tasks, from whipping egg whites to kneading pizza dough.

The construction of the KitchenAid 2266877 is marked by its high-quality materials. The body is crafted from sturdy metal, ensuring longevity and stability during use. Additionally, the mixer’s sleek design makes it an attractive addition to any kitchen countertop. Available in multiple colors, it can easily match different aesthetic preferences, making it as much a decorative piece as a functional appliance.

In terms of technologies, the KitchenAid 2266877 boasts an innovative planetary mixing action. This means that the mixing attachment moves in one direction while the bowl rotates in the opposite direction, ensuring that all ingredients are mixed thoroughly without any manual intervention. This feature is particularly useful for baking, as it promotes an even consistency and reduces the risk of lumps in the mixture.

The appliance comes equipped with different attachments that enhance its versatility. The standard wire whip, flat beater, and dough hook allow users to tackle a wide range of recipes, from delicate meringues to robust bread doughs. Its compatibility with additional attachments like pasta makers and food grinders further expands its functional utility, making it a valuable investment for anyone who enjoys cooking or baking.

Another remarkable characteristic of the KitchenAid 2266877 is its easy-to-use control panel. The intuitive design enables users to adjust speeds and settings effortlessly. Additionally, it features a tilt-head design, allowing for easy access to the bowl and attachments for quick installation and cleaning.

In conclusion, the KitchenAid 2266877 stands out for its powerful performance, durable construction, and versatile capabilities. This mixer is ideal for anyone looking to elevate their culinary skills while enjoying the convenience of a high-quality kitchen appliance. Its combination of technology, functionality, and style makes it a must-have for any kitchen enthusiast.
Top Page Image Contents