KitchenAid 2266877 manual Install Side Panel, Install Base Grille, Complete Installation

Page 19

Install Side Panel

If built-in area depth is 25 in. (63.5 cm) or more, side panels can be installed inside the side trim or attached to the outside of the side trim.

1.For inside side trim piece, slide front edge of routed side panel into trim piece.

2.Nail rear edge of panel to support board.

1

2

1.Support board

2.Side trim piece

IMPORTANT: KitchenAid is not responsible for the removal or addition of molding or decorative panels that would prevent the refrigerator from being serviced.

Install Base Grille

1.Remove base grille, skirt and two screws from package taped to front of refrigerator.

2.Open refrigerator door and measure the distance from the bottom of refrigerator cabinet to the floor.

2

3.Measure this same distance from the top of the bottom grille to the closest “V” groove on the grille skirt. Use a knife to score down the “V” groove and break skirt at the score line.

1

2

3

1.Grille and skirt assembly

2.Measured distance from above in step 2

3.Score “V” groove

4.Slide skirt assembly onto bottom grille.

5.Attach the bottom grille and skirt assembly to the cabinet with the two screws.

Complete Installation

1.Turn water supply line valve to “Open” position.

2.Turn refrigerator switch to ON position. Wait a few minutes. Check water line connections for leaks.

3.Open appliance doors and remove all boxes, parts packages and packing materials. See the “Cleaning” section in the Use and Care Guide for instructions. Remove protective film from door frame.

4.Install shelves and bins in refrigerator and freezer compartments.

5.Set refrigerator and freezer compartment controls to the midpoint setting. Check that the compressor is operating properly and that all lights are working.

6.Flush water system before using. See the “Water System Prep” section in the Use and Care Guide.

NOTE: If construction will continue after refrigerator has been installed, set controls to OFF.

To get the most efficient use from your new built-in refrigerator, read your Use and Care Guide. Keep Installation Instructions and Guide near the built-in refrigerator for easy reference.

1

1.Floor

3

2.Refrigerator cabinet bottom

3.Distance to be measured

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Built-In RefrigeratorsSide bySide and Bottom Mount Installation GuideGuide D’INSTALLATION Manual DE InstalaciónÍndice Table of ContentsTable DES Matières Your safety and the safety of others are very important Refrigerator SafetyTop View All models Product DimensionsTools and Parts Side View All modelsWidth of Refrigerator Model Width a as shown above Opening DimensionsLocation Preparation Location RequirementsWidth of Opening Model Width a as shown above Water Supply Requirements Electrical RequirementsTipping Radius Bottom Mount Models Door Swing Dimensions Door Swing DimensionsSide Tipping Radius see chart following Side by Side Door Swing DimensionsFactory Panels and Kits Door Panels for Non-dispenser Models Custom Top Grille and Door PanelsDoor Panels for Dispenser Models Door Panel Routing Refrigerator and Freezer Door PanelsRouting for Custom Top Grille and Door Panels all models Top Grille Panel RoutingFlush Side Panel End View of Side Trim Dimensions Inset Side PanelCustom Side Panels Side by Side and Bottom Mount Side PanelsModel Reduced Tipping Radius Installation InstructionsUnpack Refrigerator Reduce Tipping RadiusWraparound models Install Anti-Tip BoardsInstall New Water Line To install anti-tip boardsPlug in Refrigerator Style 1 Connecting to a Water LineStyle 2 Connecting to a Water Valve Water System ConnectionLevel Refrigerator Install Door PanelsMove Refrigerator to Final Position Lower Leveling LegsDoor Height Adjustment Adjust DoorsDoor Alignment Door Swing Adjustment Install Decorative Top PanelAdding a Decorative Panel to the Top Grille Assembly Install Base Grille Install Side PanelComplete Installation Su seguridad y la seguridad de los demá s es muy importante Seguridad DEL RefrigeradorHerramientas requeridas Medidas del productoPiezas y herramientas Vista lateral Todos los modelosMedidas de abertura Vista superior Todos los modelosVista frontal para los modelos de dos puertas Vista delantera para los modelos de montaje inferiorCm mín Requisitos de ubicaciónSuministro de agua fría Requisitos eléctricosRequisitos de suministro de agua Método de conexión a tierra recomendadoArco de vuelco hacia adelante igual para todos los modelos Arco de vuelcoMedidas de oscilación de las puertas Medidas de oscilación de dos puertasJuegos de paneles para puertas de fábrica Paneles y juegos de fábricaMedidas de oscilación de las puertas de montaje inferior Juegos de paneles y agarraderas de dos puertasJuego de rejilla superior para modelos envolventes Paneles a la medida para la rejilla Superior y las puertasJuego para rejilla superior Juego para rejilla superior de modelos con panelContorneado del panel de la rejilla superior Paneles de puerta para modelos sin despachadorPaneles de puerta para modelos con despachador Paneles de puertas de refrigerador y congeladorMedidas del adorno lateral visto desde atrás Paneles laterales a la medidaContorneado del panel de la puerta Paneles laterales de dos puertas y de montaje inferiorPanel lateral al ras Instrucciones DE InstalaciónCómo desempacar su refrigerador Panel lateral en relieveModelos con paneles Cómo reducir el arco de vuelcoCómo instalar los tableros anti-vuelco Modelo Arco de vuelco reducidoCómo conectar el sistema de agua Instalación de una tubería de agua NuevaCómo instalar los tableros antivuelco Ubicación final del refrigerador Cómo enchufar el refrigeradorEstilo 2 Conexión a una válvula de agua Modelos con panel Patas niveladoras inferioresCómo instalar los paneles de la puerta Cómo nivelar el refrigeradorCómo alinear las puertas Cómo ajustar las puertasCómo ajustar la altura de la puerta Cómo ajustar la oscilación de las puertas Cómo instalar el panel decorativo SuperiorCómo instalar la rejilla de la base Cómo instalar el panel lateralCómo terminar la instalación Votre sé curité et celle des autres est trè s importante Sécurité DU RéfrigérateurVue latérale Tous les modèles Exigences ’INSTALLATIONDimensions du produit Outillage et pièces nécessairesVue avant pour les modèles côte à côte Dimensions de l’ouverturePréparation de lemplacement Vue de dessus Tous les modèlesRisque dexplosion Exigences d’emplacementSpécifications de l’alimentation en eau Spécifications électriquesRayon de basculement Modèles de 48 po 122 cm Dimensions pour le pivotement Des portesRayon de basculement latéral voir le tableau suivant Modèles de 42 po 106 cmEnsemble de la grille supérieure Ensembles de panneaux dorigineEnsembles de panneaux de porte dorigine Ensembles de poignées de porte prolongéesCouleur Ouverture vers Ouverture vers la La gauche Droite Panneaux personnalisés de la grille Supérieure et de portePanneaux de porte pour modèles sans distributeur Panneaux de porte pour modèles avec distributeurUsinage du panneau de la grille supérieure Panneaux de porte de réfrigérateur et de congélateurUsinage du panneau de porte Panneau latéral en affleurement Dimensions pour lusinage du panneau de porte vue latéralePanneaux latéraux personnalisés Panneau latéral inséréPanneau latéral inséré en retrait Instructions ’INSTALLATIONDéballage du réfrigérateur Réduction du rayon de basculementModèles à portes enveloppantes Installation de planches Anti-basculementInstallation des planches antibasculement Modèles à panneauxRaccordement de la canalisation d’eau Installation d’une nouvelle Canalisation d’eauStyle 2 Raccordement au robinet deau Déploiement des pieds de nivellement Déplacement du réfrigérateur à Lemplacement finalInstallation des panneaux de porte Brancher le réfrigérateurRéfrigérateurs côte à côte Nivellement du réfrigérateurAjustement des portes Alignement des portesAjustement de l’ouverture des portes Ajustement de la hauteur des portesRéfrigérateurs superposés Installation du panneau latéral Installation du panneau décoratif SupérieurAddition dun panneau décoratif à la grille supérieure Achever l’installation Installation de la grille de la baseAll rights reserved 2266877

2266877 specifications

The KitchenAid 2266877 is an essential kitchen appliance that epitomizes convenience, durability, and style. As part of KitchenAid’s renowned lineup, this model is designed to cater to both amateur cooks and seasoned chefs. One of its standout features is the robust motor that ensures efficient mixing and kneading, while maintaining a quiet operation. This powerful motor is complemented by a range of speed settings, allowing users to choose the perfect speed for various tasks, from whipping egg whites to kneading pizza dough.

The construction of the KitchenAid 2266877 is marked by its high-quality materials. The body is crafted from sturdy metal, ensuring longevity and stability during use. Additionally, the mixer’s sleek design makes it an attractive addition to any kitchen countertop. Available in multiple colors, it can easily match different aesthetic preferences, making it as much a decorative piece as a functional appliance.

In terms of technologies, the KitchenAid 2266877 boasts an innovative planetary mixing action. This means that the mixing attachment moves in one direction while the bowl rotates in the opposite direction, ensuring that all ingredients are mixed thoroughly without any manual intervention. This feature is particularly useful for baking, as it promotes an even consistency and reduces the risk of lumps in the mixture.

The appliance comes equipped with different attachments that enhance its versatility. The standard wire whip, flat beater, and dough hook allow users to tackle a wide range of recipes, from delicate meringues to robust bread doughs. Its compatibility with additional attachments like pasta makers and food grinders further expands its functional utility, making it a valuable investment for anyone who enjoys cooking or baking.

Another remarkable characteristic of the KitchenAid 2266877 is its easy-to-use control panel. The intuitive design enables users to adjust speeds and settings effortlessly. Additionally, it features a tilt-head design, allowing for easy access to the bowl and attachments for quick installation and cleaning.

In conclusion, the KitchenAid 2266877 stands out for its powerful performance, durable construction, and versatile capabilities. This mixer is ideal for anyone looking to elevate their culinary skills while enjoying the convenience of a high-quality kitchen appliance. Its combination of technology, functionality, and style makes it a must-have for any kitchen enthusiast.
Top Page Image Contents