Move Refrigerator to Final Position
IMPORTANT: To prevent floor damage, make sure levelers are raised (not touching floor) and refrigerator is on rollers before moving.
1.Place top of cardboard carton or plywood under refrigerator. Remove dolly.
2.Do not remove protective film.
3.Move the refrigerator straight back and evenly into the opening. Check to make sure that water tubing is not kinked and power supply cord is on top of refrigerator next to the cover.
Lower Leveling Legs
NOTE: All four leveling legs must contact the floor to support and stabilize the full weight of refrigerator. Rollers are for moving refrigerator and not for permanent support.
Use socket wrench to turn leg levelers on both sides of refrigerator to the right (clockwise) until refrigerator weight is supported by leveling legs. The rollers should be off the floor. To avoid cabinet damage, do not apply more than 50 in./lbs.
(58 cm/kg) of torque to the leveling legs.
1 2
1.Rear leveling legs
2.Front leveling legs
Install Door Panels
Panel Models:
1.Remove all tape and door bracing from refrigerator and freezer doors. Remove screws attaching handles to door frame.
2.Slide decorative door panels into door frames.
3.If needed, route door panels or install a filler panel between doors and decorative panels. See the “Custom Top Grille and Door Panels” section.
1
2 |
3
|
|
| 4 |
1. | Filler panel | 3. | Door handle |
2. | Nylon washer | 4. | Door panel |
4.Replace door handles. Check that the top of both door handles are aligned.
5.If door handles are not aligned, loosen all handle screws and adjust door handles up or down. Tighten screws. If any of the door screws are damaged, replace them with additional screws provided in the parts package.
Level Refrigerator
NOTE: Door panels must be installed before leveling.
1.Open the doors and place the level on top of the refrigerator frame as shown. Check to see whether the refrigerator is level from left to right.
Side by Side
1 |
2 |
2 |
1.Level to check left to right leveling
2.Level to check front to back leveling
Bottom Mount
1 |
2 |
1.Level to check left to right leveling
2.Level to check front to back leveling
16