Replacing the Halogen lamps:
Before you begin, make sure that the range hood is turned off and that the other lamps have had sufficient time to cool. Halogen bulbs burn extremely hot.
To replace a halogen lamp:
•Remove 2 screws from the circular metal trim around the lamp assembly.
•Pull the trim with the lamp assembly attached down far enough so that the lamp can be pushed out of the socket.
•Insert the new lamp into the socket and push the lamp and trim assembly back up into the hood.
•Replace the trim.
Operation
The canopy hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.
Opening the canopy hood control panel:
The hood controls are located on the
controls
light | blower | blower speed |
switch | switch | switch |
Operating the light:
ON: Move the light switch to the “1” position.
OFF: Move the light switch to the “0” position.
Operating the blower:
ON: Move the blower switch to the “1” position.
OFF: Move the blower switch to the “0” position.
Adjusting the blower speed:
The blower has three speed control.
Move the blower speed switch to: “1” position for low speed,
“2” position for medium speed, or “3” position for high speed.
Cleaning
Filters:
The filters should be washed frequently. Place metal filters in dishwasher or hot detergent solution to clean.
To remove filters:
•Pull knob forward, toward the front of the hood, while turning the knob to the left (counter- clockwise) to release the locking lever.
To reinstall filters, see Step 16.
Exterior surfaces:
•Do not use steel wool or soap- filled scouring pads.
•Rub in direction of the grain line to avoid marring the surface.
•Always wipe dry to avoid water marks.
•KitchenAid® Professional Formula Stainless Steel Cleaner & Polish is the cleaner recommended for cleaning stainless steel surfaces on this product.To order call our Customer Service Center at
•If commercial cleaners are used, follow label directions. Do not use products that contain chlorine (bleach). Chlorine is a corrosive substance.
For routine cleaning and fingerprints, use liquid detergent soap and water, or
Installation kits available from your dealer
Optional Installation Kits available from your dealer.
Note: Kits are available in stainless steel only.
Backsplash: Must be installed before hood is installed. 36" (91.4 cm) hood: Kit No. 8284756
42" (106.7 cm) hood: Kit No. 8284827
48" (121.9 cm) hood: Kit No. 8284755
Vent covers: 12" (30.5 cm) high, 12" 30.5 cm) deep. 36" (91.4 cm) hood: Kit No. 8284753
42" (106.7 cm) hood: Kit No. 8284828
48" (121.9 cm) hood: Kit No. 8284752
Chimney extensions: extends from 12" (30.5 cm) to 23" (58.4 cm) high. For use with 36" (91.4 cm),
42" (106.7 cm) and 48" (121.9 cm) hoods: Kit No. 8284754
Vent transition: transitions from two
(8.3 x 25.4 cm) vents to one 10" (25.4 cm) round vent. Not for use with chimney extension Kit No. 8284754.
36" (91.4 cm) hood: Not available
42" (106.7 cm) hood: Not available
48" (121.9 cm) hood: Kit No. 8284757
9