KitchenAid YKGST300 Using and replacing the surface light, To turn the surface light on or off

(Some freestanding models)

The surface light is in the backguard. It is controlled by the SURFACE LIGHT pad on the control panel. (See “Using the electronic oven control” section for location information.)

To turn the surface light on or off:

PRESS

4.Grasp the fluorescent light tube at both ends. Turn the tube approximately 90° in either direction until both ends come out of the receptacles. Replace with a 20-watt cool-white fluorescent light tube.

Replacing the surface light:

1. Unplug range or disconnect power.

2.Flip up the top of the backguard.

3.Pull up glass on front of backguard.

5.If the surface light still does not work, you may need to replace the starter. The starter is a knob-shaped part located on the right side of the backguard, under the light tube. To remove and replace the starter, first remove light tube. Push starter in and turn approximately 90° counterclockwise. Pull starter out of recessed area. You can find replacement starters at stores that sell fluorescent light tubes.

6.Replace glass and close the top panel.

7.Plug in range or reconnect power.