■Route water supply line and drain hoses into the cabinet.
■Slide dishwasher partway into the cabinet opening. Allow for access to the electrical terminal box.
Connect Water Supply Line and Drain
Hoses
1.Connect water supply line to the water valve under the sink.
A
A. Hot water supply
4.Slide clamp into position (figures C and D).
A | B |
C | D |
5.Connect the drain hose using one of the following options:
Option 1: Waste Disposer No Drain Air Gap
AC
B
A. For new construction, remove disposer plug.
B. Connect drain connector to waste disposer.
C. Tighten clamp.
NOTE: This connection must be before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. It is recommended that the drain hose be looped up and securely fastened to the underside of the counter.
Option 2: No Waste Disposer and Drain Air Gap
A 
2.Slide clamps onto drain hoses (Figure A). Do not cut drain hoses.
3.Push hose into drain connector until fully seated (Figure B). Several “clicks” will be heard.
B 
C
A. Drain air gap
B. Drain hose connector C. Waste
11