Assembling your Sunbeam Juice Life
Before Use
After unpacking your Sunbeam Juice Life Juicer, we recommend that you disassemble the unit before using for the first time. Wash all parts except the motor body in hot soapy water. Rinse and dry immediately.
Important: Always ensure your juicer is unplugged from the power outlet when not in use, during assembling or whilst removing parts.
1.Insert the juicing screw into the juicer body, figure 8.
2. Then, add the following, figure 9;
a. Juice strainer (or blank strainer).
b. The strainer cap. Tighten it by turning it to the left or
c. Finally, add the juicing end nozzle (the
one with the green washer) or any of the other seven end nozzles. Tighten by turning left or
3.Set the motor body on a dry, level surface. Make sure the power cord is unplugged during assembly.
4.Insert the juicer body and its gear shaft into the motor body. Then lock the juicer body by turning the locking nut clockwise, figure 10.
[Insert drawing]
5.Insert the hopper onto the top of the juicer body chute and slide both the juice (small) and the pulp (bigger) containers underneath the juicer body. The juice container sits closest to the motor, figure 11.
7