COMMON DISHWASHING PROBLEMS AND
SOLUTIONS
PROBLEM | POSSIBLE CAUSE | POSSIBLE SOLUTION |
Dishwasher will not start | Dishwasher not receiving Electrical | Check electrical connection: |
| power. | Fuse/circuit breaker. |
| Door is unlatched | Close and latch door. |
| Dishwasher not level. | Level unit. |
|
|
|
Dishes not clean | Improper loading | Arrange dishes so spray action |
|
| reaches all surfaces. |
|
| Do not overload dishwasher. |
| Spray arm not rotating freely | Check spray arm to make sure |
|
| nothing (i.e. cutlery) is obstructing |
|
| spray arm rotation. |
|
| Check if filter screen has become |
|
| dislodged and obstructing spray arm |
|
| rotation. |
| Not enough detergent and/or | Use more dishwasher detergent |
| improper detergent being used. | Do not use detergent that is hard or |
|
| cracked. |
|
| Use only a recommended dishwasher |
|
| detergent. |
| Improperly prepared dishes. | Excess food soil and liquids should |
|
| be removed from dishes before |
|
| loading. |
| Water inlet hose kinked/bent due to | Eliminate kink or bend from Inlet |
| improper installation. | hose. |
|
|
|
Chipping or breaking glassware | Improper loading of dishes. | Do not overload dish rack. Load |
|
| glasses on the upper rack only, not |
|
| over dish rack pins. Glasses loaded |
|
| over dish rack pins are not properly |
|
| supported and subject to damage. |
|
|
|
Water remains in bottom | A small amount of water (in sump | This is necessary to keep the pump |
| area) is normal. | primed and is drained automatically at |
|
| the beginning of each cycle. |
|
|
|
Dishwasher can’t stop | Excessive amount of water; cycle not | Allow dishwasher to complete full |
| completed. | cycle. |
The draff is too much;
Drain the water out and clear the filter.
18