Hobart HGC4832, ML-126181, HGC6024, HGC3018, HGC4018, ML-126180, ML-126184, ML-126187 Cleaning, Daily

Page 17

CLEANING

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE CLEANING.

Daily

Clean the outside of the oven daily by wiping with a clean damp cloth.

•Avoid using abrasive powders or pads; these cleaners may damage the finish. Clean right-hand and left-hand crumb trays (Fig. 7).

1.Remove and wash in a sink as you would any normal utensil.

2.Replace crumb trays.

Clean center crumb tray (Fig. 7).

1.Remove the front panel.

a.Grasp each side of the door handle and lift up.

b.Swing the bottom of the front panel out.

c.Lower panel and pull away.

2.Loosen the conveyor belt (see Conveyor Belt Removal in this manual) and brush away the crumbs under the belt.

3.Remove crumb tray.

4.Wash in a sink as you would any normal utensil.

5.Replace the tray and the front panel by reversing the procedure.

CRUMB TRAYS

Fig. 7

PL-41127-1

— 17 —

Image 17

Contents Model HGC Series GAS Conveyor Ovens For Your Safety Important for Your SafetyTable of Contents Unpacking InstallationLocation Canada Installation Codes and StandardsUnited States of America Installing Basic Oven AssemblyOvens Mounted on Legs or Feet Ovens Mounted on CastersTesting the GAS Supply System Installing Stacked OvensLeveling GAS ConnectionsElectrical Connections Controls Figs OperationLoad Indicator Light Temperature DisplayTime Range Switch Belt SwitchAlternate Controls Fig Set Point Arrows Set Point Indicator LightControl Circuit Fuse Drive Motor FusesLighting Instructions Before First USETurning the Oven On Turning the Oven OffExtended Shutdown Using the OvenAir Distribution Panels Loading and Unloading the OvenDaily CleaningConveyor Remove Cover Weekly Conveyor Belt Assembling and Disassembling Fig Type APPROX. Time Temp Food Product MIN Italian Cooking ChartBreads & Subs BakeryInspection MaintenanceService and Parts Information Problem Possible Causes Action Troubleshooting Guide