Frymaster FPHD manual Removing gas manifold shield

Page 27

HIGH EFFICIENCY DECATHLON SERIES GAS FRYERS

CHAPTER 1: SERVICE PROCEDURES

1.7.8 Replacing the Frypot (cont.)

10.Remove screws securing flue cap to frypot (access from above; a nut-driver with an extension or long screwdriver is required). Use care not to drop the screws into the flues. If this happens, the screws can be retrieved when the flue is removed (Step 16). Use a screwdriver or similar tool to free flue cap from frypots. Remove flue cap by lifting up and off of fryer.

Remove the screws (arrow) securing the flue cap to the frypot on the long edge. There will be two or three screws depending on configuration. (view from above, looking down into flue)

Remove the screws (arrows) securing the flue cap to the frypot on the short edge. There will be two screws on each end of the flue. (view from above, looking down into flue)

11.Remove gas manifold pipe for access to gas manifold shield by disconnecting at the unions. Ensure gas supply is shut off and supply line is disconnected prior to removing. Set gas manifold aside. Remove screws securing gas manifold shield. Remove shield to access oil- return plumbing components connected to the frypots.

NOTE: For units without built-in filtration skip the steps pertaining to removal and replacement of oil-return plumbing.

Removing gas manifold shield.

1-22

Image 27

Contents Hour Service Hotline Includes HD63/Red Robin and Common CabinetryMAY Page Computers FCC Table of Contents Page GAS Information Altitudes of 2000 feet or less Functional DescriptionElectronic Ignition Configuration Pilot System ConfigurationInterface Boards Control OptionsThermatron Board P/N Interface Boards Indicates power from 12V transformer Test Meter Setting Pins Test ResultsThermostats Accessing Fryers for ServicingRestraints Adjusting Burner Manifold Gas Pressure Cleaning the Gas Valve Vent Tube if applicableTrailing Pilot Adjusting the Pilot FlameCalibrating the Thermatron Main PilotReplacing the Computer Replacing Fryer ComponentsReplacing the Temperature Probe Computer-equipped Fryers Replacing the Temperature Probe Computer-equipped Fryers Probe cannot be repositioned Replacing the High-limit Thermostat Installing the New Temperature ProbeLocate the high-limit probe Capillary tube cannot be repositioned Figure B Replacing Rocker SwitchesReplacing Rocker Switches Replacing the Frypot Replacing the Pilot AssemblyRemoving the joiner strip Removing gas manifold shield Removing bolts arrows securing flue to frypot Nut Valve Boot Clamp Remove the drain valve nut and attached Hardware Cutting frypot seal prior to frypot removal Lifting frypot from fryer Ignition Failure Troubleshooting and Problem IsolationImproper Burner Function Electronic CircuitsImproper Burner Function Improper Temperature Control Improper Computer Function Improper Filtration Function Frypot Leakage Improper Basket Lift Function Bell-Crank Basket Lifts Problem Troubleshooting GuidesNot possible Wiring Diagrams High Efficiency Decathlon, Thermatron with Constant PilotRight/left sides are the same Computer with Constant Pilot CM4-S Wiring Dean Oil Return Wiring Dean Oil Return Wiring, with Solenoid Probe Resistance Charts High Efficiency Decathlon HD Primary Components High Efficiency Decathlon Series GAS Fryers Parts ListDecathlon HD50 Primary Components includes Scfhd units See Orifices, SectionSee Drain Manifold Components, Section Decathlon HD50 Primary Components includes Scfhd units 823-4692 Decathlon HD60 Primary Components includes Scfhd unitsFlue Box Assembly also used on HD63 fryers Front, Flue Box Decathlon FPHD65 Primary Components Channel, Base 265 465 565 Cabinet Upper BackCabinet Lower Back Door Assembly, with Liner also used for HD63 fryers Orifices Natural OrificesPropane Orifices Joiner Strips Control Panel Options, Joiner Strips, and AccessoriesAccessories Control PanelsOptional Components and Controllers HD/SCFHD50 SCFHD456 SCFHD60 BezelsInterface Boards High Efficiency Decathlon Series GAS Fryers Parts List Drain Valve Assembly, 1 1 ⁄ 2 without Microswitch Drain Valve Assembly, 1 1 ⁄ 2 with MicroswitchFlush Oil Drain Line Oil Return Manifold Components Oil Return Manifold Components Oil Return Manifold Components Oil Return and Oil Flush Components Oil Suction Start Fitting Microswitch Bracket Assembly, Oil ReturnOil Suction Assembly Suction Manifold AssemblyDescription 106-7543 Filtration Components SCFHD60 and SCFHD63 Series FryersFiltration Components FPHD65 Series Fryers Basket Lift Components Basket Lift Components Trough, Holster, & Cover Components Fasteners Screws, Nuts, Bolts Service Hotline