Frymaster OCF30 operation manual Reassembly, Draining and Disposing of Waste Oil

2.At each scheduled boil-out, disassemble the leaf filter assembly and place in the frypot being boiled out. Follow the boil-out procedure in Section 5.3.2 of this manual.

3.Allow all filter assembly components to air dry or thoroughly dry with clean towels before reassembling.

Reassembly

1.Place the two outer screens together and align their edges (see illustration below).

2.Insert the screens into one of the frame halves (it doesn’t matter which one). Ensure that the fitting in the bottom screen is on the opposite side of the frame from the handle.

3.Slip the grid between the screens, ensuring that the grid is centered between the edges of the screens.

4.Connect the other half of the frame at the corner opposite the handles and pivot the frame onto the free edges of the screen.

Steps 1 and 2 - Stack outer screens and insert edges into frame.

Step 3 - Insert grid between screens after screens have been positioned in frame.

Step 4 - Connect corner then pivot frame over free edges of screens.

Handle

4.4Draining and Disposing of Waste Oil

When cooking oil is exhausted, the oil must be drained into the filter pan, SDU or other appropriate METAL container for transport to the disposal container or if a bulk oil system is installed, use the

bulk oil disposal system by selecting DISPOSE from the filter menu if the fryer is equipped with a 3000 (see page 1-13 of the 3000 controller manual 819-6872.) and follow the prompts and instructions for disposing oil to the bulk oil system. (For safe, convenient draining and disposal of used oil, Frymaster recommends the use of the Frymaster Shortening Disposal Unit (SDU) for JIB systems. The SDU is available through your local distributor.) NOTE: If using an SDU built before January 2004 the filter pan cover must be removed to allow the unit to be positioned beneath the drain. To remove the lid, lift up on the front edge and pull it straight out of the cabinet. Refer to the documentation furnished with your disposal unit for specific operating instructions. If a shortening

4-6