2.Disconnect the fryer from the electrical power supply.
3.Remove the two screws securing the cover of the contactor box. The contactor boxes above the filter pan are accessed by sliding under the fryer. They are located to the left and right above the guide rails (see photo below). The contactor boxes of
Remove two screws to access contactor box components above the filter pan.
4.The contactors and relays are held on by threaded pin studs so that only removal of the nut is required to replace the component.
5.After performing necessary service, reverse steps
Left and right views of mechanical contactor box components.
1.8 Replacing a Frypot
1.Drain the frypot into the filter pan or, if replacing a frypot over the filter system, into a Shortening Disposal Unit (SDU) or other appropriate metal container. If replacing a frypot over the filter system, remove the filter pan and lid from the unit.
DANGER
DO NOT drain more than one full frypot or two split frypots into the SDU at one time.
2.Disconnect the fryer from the electrical power supply and reposition it to gain access to both the front and rear.