Frymaster E4 operation manual But oil return is very, Slow and bubbling, Oil occurs

Page 34

Problem

Probable Causes

Corrective Action

 

 

A. If using filter paper or pad

 

 

configuration, verify that filter

 

 

screen is in bottom of pan with

 

 

paper or pad on top of screen.

 

A. Improperly installed filter pan

Verify that O-rings are present

 

and in good condition on filter

 

components.

 

pan connection fitting.

 

 

Filter pump runs,

 

If using Magnasol filter

 

assembly, verify that O-ring is

but oil return is very

 

present and in good condition on

slow and bubbling

 

filter screen fitting.

oil occurs.

 

 

 

B. In order to properly filter, the

 

 

oil or shortening should be at

 

 

or near 350ºF (177ºC). At

 

 

temperatures lower than this,

 

 

the oil becomes too thick to

 

B. Attempting to filter with oil that

pass through the filter medium

 

is not hot enough.

easily, resulting in much slower

 

 

oil return and eventual

 

 

overheating of the filter pump

 

 

motor. Make sure oil is at or

 

 

near frying temperature before

 

 

draining oil into filter pan.

6-8

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Hour Service Hotline Electric Fryers RE SeriesCanada Page Table of Contents RE Series E4 Electric Fryers Introduction Safety InformationGeneral European Community CE Specific Information Computer InformationDefinitions Shipping Damage Claim Procedure Service InformationRE Series E4 Electric Fryers Installation Instructions Australian Requirements Power Requirements Three 3 Phase RequirementsPage RE Series E4 Electric Fryers Operating Instructions Finding Your WAY around the Fpre Series E4 Electric FryerSetup Equipment Setup and Shutdown ProceduresShutdown Controllers RE Series E4 Electric Fryers Filtration Instructions Page Preparation for Use with Filter Paper or Filter Pad Preparation for Use with the Magnasol Filter Assembly Page Filter Pump Reset Switch Cleaning Reassembly Draining and Disposing of Waste OilRE Series E4 Electric Fryers Preventative Maintenance Page Annual/Periodic System Inspection FryerBuilt-In Filtration System RE Series E4 Electric Fryers Operator Troubleshooting IntroductionActivate Troubleshooting Controller and Heating ProblemsController wont Fryer does not heatProblem Fryer repeatedlyError Messages and Display Problems Problem Display is in wrong Heating mode lightDigital controller Solid state controllerBasket Lift Problems Filtration ProblemsSlow and bubbling But oil return is veryOil occurs This page Intentionally Left Blank Service Hotline
Related manuals
Manual 86 pages 38.42 Kb Manual 2 pages 51.67 Kb Manual 78 pages 9.63 Kb

E4 specifications

The Frymaster E4 is an advanced fryer that represents the cutting edge of commercial frying technology. Designed for efficiency and performance, it is favored by restaurants and fast-food chains looking to optimize their cooking processes while maintaining exceptional food quality.

One of the standout features of the Frymaster E4 is its programmable controls. With an intuitive digital interface, operators can easily adjust cooking temperatures, times, and even recipes with just a few taps. This level of precision ensures that food is consistently cooked to perfection every time, reducing waste and improving overall efficiency in the kitchen.

The E4 is equipped with high-performance burners that ensure rapid heating and recovery times. This means that cooking oil reaches the desired temperatures quickly, allowing for faster frying cycles. Thus, busy kitchens can meet high-demand periods without compromising quality or service speed. The fryer also features a high-efficiency oil filtration system that automatically removes contaminants and prolongs the life of the frying oil, resulting in a significant reduction in operating costs over time.

Another notable technology in the Frymaster E4 is its oil level management system, which actively monitors oil levels and alerts the operator when replenishment is necessary. This feature prevents overfilling or underfilling, both of which can negatively impact cooking performance and food quality.

Safety is also a top priority with the E4, as it incorporates features such as a built-in safety shut-off mechanism that activates if the temperature exceeds safe levels. Additionally, the fryer's robust construction minimizes the risks of spills and accidents in the kitchen, making it a reliable choice for high-traffic environments.

The Frymaster E4 also emphasizes energy efficiency, designed to meet stringent energy-saving standards without compromising performance. This is crucial in the current market, where energy costs can significantly impact overall profitability.

In conclusion, the Frymaster E4 offers an impressive combination of innovative technology, safety, and efficiency. Its programmable controls, high-performance frying capabilities, and advanced filtration and oil management systems make it an essential tool for any commercial kitchen aiming to enhance productivity and food quality. As the demands of the food industry continue to grow, the E4 stands out as a reliable partner for chefs looking to elevate their frying operations.
Top Page Image Contents