Jenn-Air JGC9430, JGC9536 installation manual Pressure Testing, Illustrative Alternative Piping

Page 6

Alternative Piping Methods To Connect Appliance To Gas Supply

A QUALIFIED SERVICEMAN OR GAS APPLIANCE INSTALLER MUST MAKE THE GAS SUPPLY CONNECTION. Leak testing of the appliance shall be conducted by the installer according to the instructions given.

Unless prohibited by local codes or ordinances, a new A.G.A. - Certified, flexible metal appliance connector may be used to connect this appliance to its gas supply. The connector must be no more than 5 feet in length. Per figure 5, use appropriate flare union adapter at each end of the flexible connector. If a flexible connector is used assure that both the appliance pressure regulator and manual shut-off valve are joined solidly to other permanent hard piping (either gas supply or the appliance manifold) so as to be physically stationary. See illustrations below:

Pressure Testing

The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 PSIG (3.5 kPa).

This appliance, as well as its individual shut-off valve, must be disconnected from the gas supply piping system during any pressure testing of the system at test pressures in excess of 1/2 PSIG (3.5 kPa).

When checking appliance regulator function, make certain pressure of natural gas supply is between 6 and 14 inches of water column or, if converted for LP gas, between 11 and 14 inches.

ILLUSTRATIVE ALTERNATIVE PIPING

CAUTION: Do not attempt to attach the flexible connector directly to an external pipe thread. Connection requires flare union adapters.

I M P O R T A N T

Apply a non-corrosive leak detection fluid to all joints and fittings in the gas connection between the supply line shut-off valve and the range. Include gas fittings and joints in the range if connections were disturbed during installation. Check for leaks! Bubbles appearing around fittings and connections will indicate a leak. If a leak appears, turn off supply line gas shut-off valve, tighten connections, turn on the supply line gas shut off valve, and retest for leaks. Never test for gas leaks with an open flame.

Manifold

Entrance

Appliance Pressure Regulator, Supplied (Observe directionality of Gas Flow)

Flare Union Adaptor

1/2￿ N.P.T. Flexible Appliance Connector (5 ft. max.)

3/8￿ N.P.T.

Flare Union Elbow

Adaptor

3/8￿ N.P.T. Flexible Appliance Connector (5 ft. max.)

Flare Union Adaptor

Flare Union Adaptor

 

Gas Shut-Off Valve

Appliance Pressure

Regulator, Supplied

 

 

(Observe

 

directionality of Gas

1/2￿ N.P.T. Pipe

Flow)

 

(Stationary Supply Pipe)

 

 

1/2￿ N.P.T. Pipe

 

Nipple

 

Gas Shut-Off Valve

 

1/2￿ N.P.T. Pipe

 

(Stationary Supply

 

Pipe)

FIGURE 5

6

Image 6
Contents Cutout Dimensions Are Critical DimensionsLocation Of Your Jenn-Air Appliance Installing Cabinetry Over Your Jenn-Air CooktopRequired Adjustments At Time Of Installation Important Preparation SuggestionsInstallation Of Appliance Mobile HomesRecreational Park Trailers Connecting Appliance To Gas Supply If no Other Appliance is to be Installed below this CooktopIllustrative GAS Supply Piping Electric Wall Oven Installed below this Cooktop Wall Oven Installed below 30 CooktopPressure Testing Illustrative Alternative PipingElectrical Wiring Information Electrical Grounding InstructionsConverting Appliance For Use With LP Gas Replace ALL Orifice SpudsConversion of Appliance Pressure Regulator View Through Knob HoleTo Convert Appliance For Use With Natural Gas Flame Appearance AT HI and LOReset the Valves for Natural GAS Burner Ignition Auto-ReignitionDimensiones LAS Dimensiones DE Corte DEL Hueco SON DE Suma ImportanciaUbicación del electrodoméstico Jenn-Air Casas móviles Vehículos recreativosInstalación del electrodoméstico Conexión del electrodoméstico al suministro de gas Ilustración DE LA Tubería DEL Suministro DE GASCaja DEL Quemador Nota, en referencia a la Figura 4 anterior Pruebas de presión Ilustración DE LA Tubería AlternativaInformación de cableado eléctrico Instrucciones eléctricas de conexión TierraRemoción DEL Puntal DE Orificio Conversión del electrodoméstico para usarse con gas LPInstalación DE LOS Puntales DE Orificio Obturadores Coloque DE Nuevo Todos LOS Puntales DE OrificioConversión DEL Regulador DE Presión DEL Electrodoméstico Chaflán Superficie Orientado DE VidrioApariencia DE LA Llama EN Alto Bajo Instalación de los puntales de orificio de gas NaturalEncendido del quemador y reencendido automático Reajuste LAS Válvulas Para Usar GAS NaturalManuel DE Mise EN Service Respecter Impérativement LES Dimensions DE LA DécoupeSuggestions de préparation importantes Emplacement de votre appareil Jenn-AirRéglages requis lors de la mise en service Préparation du comptoirMaisons mobiles Roulottes de parcPose de l’appareil Raccordement de l’appareil au gaz Illustration D’UNE Conduite DE GAZBoîte DES Brûleurs Remarque concernant la ci-dessus Vérification de la pression Illustration D’UNE Méthode AlternativeAvertissement Câblage électriqueDépose DE L’ÉCROU À Orifice Conversion de l’appareil au gaz GPLPose DE Raccords ET DE Réducteurs DE Débit D’ORIFICE GPL Remplacer Tous LES Raccords À OrificeConversion DU Détendeur DE L’APPAREIL VUE Dans LE Trou DU BoutonPour convertir l’appareil au gaz naturel Apparence DE LA Flamme À Plein FEU ET À FEU DouxReconversion DES Commandes AU GAZ Naturel Allumage standard et allumage automatique des brûleurs

JGC9536, JGC9430 specifications

The Jenn-Air JGC9536 and JGC9430 are two prominent models in the realm of premium gas cooktops, designed to elevate culinary experiences in the modern kitchen. Both models offer a range of advanced features and technologies that cater to the needs of chefs at all skill levels.

Starting with the JGC9536, this cooktop boasts a powerful 19,000 BTU burner, ideal for rapid boiling and high-heat searing. This feature is complemented by a versatile selection of burner sizes, including a 15,000 BTU dual-flame burner, which allows for precise temperature control. This burner is particularly advantageous for simmering sauces or slow-cooking delicate dishes. Additionally, the JGC9536 incorporates powerful 6,000 BTU burners that are excellent for everyday cooking tasks, providing a good balance between heat and efficiency.

The JGC9430, while slightly smaller, does not compromise on performance. It features a robust 16,000 BTU burner that provides ample power for a variety of cooking methods. Both models are equipped with continuous cast iron grates that allow for easy movement of pots and pans across the cooktop. This design not only enhances stability but also offers a professional look to the kitchen.

A notable technology integrated into both the JGC9536 and JGC9430 is the Precision Temperature Control. This feature provides consistent heat across the burners, ensuring food is cooked evenly. The high-performance ignition system is another highlight, allowing for quick and reliable burner lighting, which is essential for busy kitchen environments.

In terms of aesthetics, both models feature sleek stainless steel finishes and a sophisticated design that complements any kitchen décor. The illuminated knobs on the front provide not only a stylish touch but also practical visibility, making it easy to operate even in low-light conditions.

Safety features are also a focus for both cooktops. The flame-sensing technology automatically re-ignites the burner if the flame goes out, providing peace of mind while cooking. Additionally, the sealed burners minimize the risk of spills and allow for easy cleaning.

In summary, the Jenn-Air JGC9536 and JGC9430 gas cooktops are top-tier choices for those seeking to enhance their cooking experience. With powerful burners, advanced temperature control technologies, and a commitment to safety and aesthetics, these cooktops stand out as excellent investments for any kitchen. Whether for everyday cooking or culinary adventures, these models deliver exceptional performance and versatility.