Jenn-Air JGC9536, JGC9430 Electrical Wiring Information, Electrical Grounding Instructions

Page 7

Electrical Wiring Information

This appliance is equipped with a grounded type power cord. A grounded outlet must be provided. It is recommended, for convenience, the outlet be located (with reference to figure 6) as in A or B, below:

A. If no other appliance is to be installed below this appliance: within either the shaded area or the cross hatched area shown in figure 6.

B. If a Model JJW8530, JJW9530, W30400P, or JJW8130 Electric Wall Oven is to be installed below this appliance, either:

1.within the cross hatched area of figure 6, or,

2.within an adjacent cabinet.

If a wall oven is to be installed below this appliance and the counter units outlet is to be mounted within the cross hatched area of figure 6:

1.The cabinet’s lower front panel, below the oven, must be made removable for access to the outlet.

2.A clearance hole for the power cord’s plug (1-1/4￿(3.18 cm) dia is recommended) must be provided through the oven’s floor support shelf and, if necessary, through the slats supporting the shelf. The clearance hole should be located as near as practical to the rear of the shelf.

If the outlet is to be mounted in either a left or right adjacent cabinet, a clearance hole, as described above, must be provided in the dividing wall between the cabinets. Figure 4; page 5, illustrates a typical (left side) dividing wall. The clearance hole (not shown in figure 4)

can be located as is convenient in this left wall or in the corresponding right wall.

In planning any installation, note that the free length of this appliance’s power cord, extending beyond a point

3-3/4￿(9.53 cm) left of the nominal center of the rear wall of the burner box, when viewed from the front of the unit, is approximately 46￿ (117 cm).

User may experience occasional circuit tripping if Ground Fault Circuit Interrupter (GFCI) outlet or breaker is in use.

Electrical Grounding Instructions

This appliance is equipped with a (three-prong) grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug.

THIS APPLIANCE MUST BE DISCON- NECTED FROM ITS ELECTRICAL SUPPLY AT THE WALL RECEPTACLE BEFORE SERVICING THE APPLIANCE.

3 13/16￿

9.7 cm

29 3/8￿

74.61 cm

37 3/16￿

94.46 cm

3 1/2￿ (8.89 cm) WIDE

4￿ MAX.

SLATS WHEN A WALL

10.16 cm

OVEN IS INSTALLED

CABINET BOTTOM

BELOW 30￿ MODEL

 

FIGURE 6

7

Image 7
Contents Dimensions Cutout Dimensions Are CriticalImportant Preparation Suggestions Installing Cabinetry Over Your Jenn-Air CooktopRequired Adjustments At Time Of Installation Location Of Your Jenn-Air ApplianceMobile Homes Installation Of ApplianceRecreational Park Trailers If no Other Appliance is to be Installed below this Cooktop Connecting Appliance To Gas SupplyIllustrative GAS Supply Piping Wall Oven Installed below 30 Cooktop Electric Wall Oven Installed below this CooktopIllustrative Alternative Piping Pressure TestingElectrical Grounding Instructions Electrical Wiring InformationReplace ALL Orifice Spuds Converting Appliance For Use With LP GasView Through Knob Hole Conversion of Appliance Pressure RegulatorFlame Appearance AT HI and LO To Convert Appliance For Use With Natural GasBurner Ignition Auto-Reignition Reset the Valves for Natural GASLAS Dimensiones DE Corte DEL Hueco SON DE Suma Importancia DimensionesUbicación del electrodoméstico Jenn-Air Vehículos recreativos Casas móvilesInstalación del electrodoméstico Ilustración DE LA Tubería DEL Suministro DE GAS Conexión del electrodoméstico al suministro de gasCaja DEL Quemador Nota, en referencia a la Figura 4 anterior Ilustración DE LA Tubería Alternativa Pruebas de presiónInstrucciones eléctricas de conexión Tierra Información de cableado eléctricoColoque DE Nuevo Todos LOS Puntales DE Orificio Conversión del electrodoméstico para usarse con gas LPInstalación DE LOS Puntales DE Orificio Obturadores Remoción DEL Puntal DE OrificioChaflán Superficie Orientado DE Vidrio Conversión DEL Regulador DE Presión DEL ElectrodomésticoInstalación de los puntales de orificio de gas Natural Apariencia DE LA Llama EN Alto BajoReajuste LAS Válvulas Para Usar GAS Natural Encendido del quemador y reencendido automáticoRespecter Impérativement LES Dimensions DE LA Découpe Manuel DE Mise EN ServicePréparation du comptoir Emplacement de votre appareil Jenn-AirRéglages requis lors de la mise en service Suggestions de préparation importantesRoulottes de parc Maisons mobilesPose de l’appareil Illustration D’UNE Conduite DE GAZ Raccordement de l’appareil au gazBoîte DES Brûleurs Remarque concernant la ci-dessus Illustration D’UNE Méthode Alternative Vérification de la pressionCâblage électrique AvertissementRemplacer Tous LES Raccords À Orifice Conversion de l’appareil au gaz GPLPose DE Raccords ET DE Réducteurs DE Débit D’ORIFICE GPL Dépose DE L’ÉCROU À OrificeVUE Dans LE Trou DU Bouton Conversion DU Détendeur DE L’APPAREILApparence DE LA Flamme À Plein FEU ET À FEU Doux Pour convertir l’appareil au gaz naturelAllumage standard et allumage automatique des brûleurs Reconversion DES Commandes AU GAZ Naturel

JGC9536, JGC9430 specifications

The Jenn-Air JGC9536 and JGC9430 are two prominent models in the realm of premium gas cooktops, designed to elevate culinary experiences in the modern kitchen. Both models offer a range of advanced features and technologies that cater to the needs of chefs at all skill levels.

Starting with the JGC9536, this cooktop boasts a powerful 19,000 BTU burner, ideal for rapid boiling and high-heat searing. This feature is complemented by a versatile selection of burner sizes, including a 15,000 BTU dual-flame burner, which allows for precise temperature control. This burner is particularly advantageous for simmering sauces or slow-cooking delicate dishes. Additionally, the JGC9536 incorporates powerful 6,000 BTU burners that are excellent for everyday cooking tasks, providing a good balance between heat and efficiency.

The JGC9430, while slightly smaller, does not compromise on performance. It features a robust 16,000 BTU burner that provides ample power for a variety of cooking methods. Both models are equipped with continuous cast iron grates that allow for easy movement of pots and pans across the cooktop. This design not only enhances stability but also offers a professional look to the kitchen.

A notable technology integrated into both the JGC9536 and JGC9430 is the Precision Temperature Control. This feature provides consistent heat across the burners, ensuring food is cooked evenly. The high-performance ignition system is another highlight, allowing for quick and reliable burner lighting, which is essential for busy kitchen environments.

In terms of aesthetics, both models feature sleek stainless steel finishes and a sophisticated design that complements any kitchen décor. The illuminated knobs on the front provide not only a stylish touch but also practical visibility, making it easy to operate even in low-light conditions.

Safety features are also a focus for both cooktops. The flame-sensing technology automatically re-ignites the burner if the flame goes out, providing peace of mind while cooking. Additionally, the sealed burners minimize the risk of spills and allow for easy cleaning.

In summary, the Jenn-Air JGC9536 and JGC9430 gas cooktops are top-tier choices for those seeking to enhance their cooking experience. With powerful burners, advanced temperature control technologies, and a commitment to safety and aesthetics, these cooktops stand out as excellent investments for any kitchen. Whether for everyday cooking or culinary adventures, these models deliver exceptional performance and versatility.