Jenn-Air JGC9430, JGC9536 Location Of Your Jenn-Air Appliance, Important Preparation Suggestions

Page 2

Location Of Your Jenn-Air Appliance

Locate this appliance away from combustible materials such as window curtains and combustible wall decorations.

Minimum horizontal clearance between the edge of the appliance and combustible construction extending from the cooking surface to 18￿ (45.72 cm) above the cooking surface is:

1￿ (2.54 cm) at rear

6￿ (15.24 cm) at sides

(Dimensions apply to both 30￿ and 36￿ wide models).

Important Preparation

Suggestions

1.Chamfer all exposed edges of decorative laminate to prevent damage from chipping.

2.Radius corners of cutout and file to insure smooth edges and prevent corner cracking. Recommend 1/4￿ or 3/8￿ diameter drill in each corner.

3.Rough edges, inside corners which have not been rounded and forced fits can contribute to cracking of the countertop laminate.

4.Countertop must be supported within 3￿ (7.62 cm) of cutout.

3/4￿

1.91 cm

18￿

45.72 cm

8￿

20.32 cm

FIGURE 1

Preparation Of Countertop

The countertop cutout must be prepared according to the illustration on page 1 of these instructions.

CAUTION: Cutout dimensions are critical. Dimensions must be measured and cut accurately to within + 1/16￿ (.159 cm) to ensure proper fit.

Installing Cabinetry Over Your Jenn-Air Cooktop

A = 30￿ (76.2 cm) minimum vertical clearance between cooking surface and construction above the appliance. This clearance may be reduced to not less than 24 inches (60.96 cm) by protecting the underside of the combustible material or metal cabinet above the cooking surface with not less than 1/4 inch (.635 cm) insulating millboard

covered with sheet metal

not less than 0.0122 inch FIGURE 2 thick.

B = 13￿ (33.02 cm) maximum depth of cabinets installed above cooktop.

Avoid use of cabinets above cooktop for storage space to eliminate associated potential hazards such as reaching over open flames.

Required Adjustments At Time Of Installation

The installation of this appliance must conform with local codes, or in the absence of local codes, with the latest edition of the National Fuel Gas Code ANSI Z223.1 USA or current CAN/CGA-B149

INSTALLATION CODE.

VThis appliance was manufactured for use with Natural Gas. If LP gas is the fuel of choice, follow the conversion to LP procedure found in the installation instructions.

V V

Test all external connections for gas leaks. Never test for gas leaks with an open flame.

Test all electrical connections.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Cutout Dimensions Are Critical DimensionsLocation Of Your Jenn-Air Appliance Installing Cabinetry Over Your Jenn-Air CooktopRequired Adjustments At Time Of Installation Important Preparation SuggestionsRecreational Park Trailers Installation Of ApplianceMobile Homes Illustrative GAS Supply Piping Connecting Appliance To Gas SupplyIf no Other Appliance is to be Installed below this Cooktop Electric Wall Oven Installed below this Cooktop Wall Oven Installed below 30 CooktopPressure Testing Illustrative Alternative PipingElectrical Wiring Information Electrical Grounding InstructionsConverting Appliance For Use With LP Gas Replace ALL Orifice SpudsConversion of Appliance Pressure Regulator View Through Knob HoleTo Convert Appliance For Use With Natural Gas Flame Appearance AT HI and LOReset the Valves for Natural GAS Burner Ignition Auto-ReignitionDimensiones LAS Dimensiones DE Corte DEL Hueco SON DE Suma ImportanciaUbicación del electrodoméstico Jenn-Air Instalación del electrodoméstico Casas móvilesVehículos recreativos Caja DEL Quemador Conexión del electrodoméstico al suministro de gasIlustración DE LA Tubería DEL Suministro DE GAS Nota, en referencia a la Figura 4 anterior Pruebas de presión Ilustración DE LA Tubería AlternativaInformación de cableado eléctrico Instrucciones eléctricas de conexión TierraRemoción DEL Puntal DE Orificio Conversión del electrodoméstico para usarse con gas LPInstalación DE LOS Puntales DE Orificio Obturadores Coloque DE Nuevo Todos LOS Puntales DE OrificioConversión DEL Regulador DE Presión DEL Electrodoméstico Chaflán Superficie Orientado DE VidrioApariencia DE LA Llama EN Alto Bajo Instalación de los puntales de orificio de gas NaturalEncendido del quemador y reencendido automático Reajuste LAS Válvulas Para Usar GAS NaturalManuel DE Mise EN Service Respecter Impérativement LES Dimensions DE LA DécoupeSuggestions de préparation importantes Emplacement de votre appareil Jenn-AirRéglages requis lors de la mise en service Préparation du comptoirPose de l’appareil Maisons mobilesRoulottes de parc Boîte DES Brûleurs Raccordement de l’appareil au gazIllustration D’UNE Conduite DE GAZ Remarque concernant la ci-dessus Vérification de la pression Illustration D’UNE Méthode AlternativeAvertissement Câblage électriqueDépose DE L’ÉCROU À Orifice Conversion de l’appareil au gaz GPLPose DE Raccords ET DE Réducteurs DE Débit D’ORIFICE GPL Remplacer Tous LES Raccords À OrificeConversion DU Détendeur DE L’APPAREIL VUE Dans LE Trou DU BoutonPour convertir l’appareil au gaz naturel Apparence DE LA Flamme À Plein FEU ET À FEU DouxReconversion DES Commandes AU GAZ Naturel Allumage standard et allumage automatique des brûleurs

JGC9536, JGC9430 specifications

The Jenn-Air JGC9536 and JGC9430 are two prominent models in the realm of premium gas cooktops, designed to elevate culinary experiences in the modern kitchen. Both models offer a range of advanced features and technologies that cater to the needs of chefs at all skill levels.

Starting with the JGC9536, this cooktop boasts a powerful 19,000 BTU burner, ideal for rapid boiling and high-heat searing. This feature is complemented by a versatile selection of burner sizes, including a 15,000 BTU dual-flame burner, which allows for precise temperature control. This burner is particularly advantageous for simmering sauces or slow-cooking delicate dishes. Additionally, the JGC9536 incorporates powerful 6,000 BTU burners that are excellent for everyday cooking tasks, providing a good balance between heat and efficiency.

The JGC9430, while slightly smaller, does not compromise on performance. It features a robust 16,000 BTU burner that provides ample power for a variety of cooking methods. Both models are equipped with continuous cast iron grates that allow for easy movement of pots and pans across the cooktop. This design not only enhances stability but also offers a professional look to the kitchen.

A notable technology integrated into both the JGC9536 and JGC9430 is the Precision Temperature Control. This feature provides consistent heat across the burners, ensuring food is cooked evenly. The high-performance ignition system is another highlight, allowing for quick and reliable burner lighting, which is essential for busy kitchen environments.

In terms of aesthetics, both models feature sleek stainless steel finishes and a sophisticated design that complements any kitchen décor. The illuminated knobs on the front provide not only a stylish touch but also practical visibility, making it easy to operate even in low-light conditions.

Safety features are also a focus for both cooktops. The flame-sensing technology automatically re-ignites the burner if the flame goes out, providing peace of mind while cooking. Additionally, the sealed burners minimize the risk of spills and allow for easy cleaning.

In summary, the Jenn-Air JGC9536 and JGC9430 gas cooktops are top-tier choices for those seeking to enhance their cooking experience. With powerful burners, advanced temperature control technologies, and a commitment to safety and aesthetics, these cooktops stand out as excellent investments for any kitchen. Whether for everyday cooking or culinary adventures, these models deliver exceptional performance and versatility.
Top Page Image Contents