Jenn-Air JGC9536, JGC9430 Burner Ignition Auto-Reignition, Reset the Valves for Natural GAS

Page 11

5.Complete Steps 5, 8 and 9 on pages 8 & 9 to complete the installation of natural gas main spuds in their correct locations.

6.Save the orifices & chokes removed from the appliance for future use. They will be needed if this appliance is again converted for use with LP gas.

C.INVERT CAP IN APPLIANCE PRESSURE REGULATOR. (See figure 12).

With the appliance installed the appliance regulator should be located as shown in either figure 3 or figure 4 (pages 4 & 5). Identify the type of appliance regulator and follow the instructions in the appropriate illustration.

D.RESET THE VALVES FOR NATURAL GAS

1.Light one burner, and set on low.

2.Remove the knob.

3.Remove the rubber grommets.

4.Locate the valve adjustment screw. See figure 13.

5.Insert a slender, thin-blade screwdriver into knob hole and engage blade with slot in adjusting screw.

6.Starting from the LP position (see #5 on page 9, under C. LOW FLAME ADJUSTMENT), turn the screw counter clockwise until the flame stabilizes and matches the pictured “low” setting on figure 14. Proper adjustment will produce a stable, steady blue flame of minimum size. The final adjustment should be checked by turning the knob from high to low several times without extinguishing the flame.

After Steps A, B and C have been completed, check the appearance of each burner’s flame at the Hi and Lo settings against figure 14. If the flames appear too large or too small, make sure all steps were completed correctly.

Burner Ignition And

Auto-Reignition

This appliance is equipped for electronic auto-reignition by means of a spark igniter located at the rear of each burner. The burners are designed to light at any valve rotation that admits sufficient gas flow to support a flame and to automatically relight following a loss of flame due to a draft or other adverse condition. This feature is provided as a convenience and is not intended as a safety feature.

CAUTION: Never cover control knobs or surrounding control surface with utensils, towels, or other objects. Never obstruct free air passage past the control knobs. The knob openings have been sized to properly control air entry to the interior of the appliance during operation.

This appliance has no air shutters. Primary air adjustments are unnecessary. The burners are designed to provide optimum aeration for all gases without air shutters. When operating properly, burners should produce clearly defined, even blue flames. If the flames have yellow tips or are hazy and otherwise appear to have insufficient air, obtain the services of a qualified service technician. Some yellow tipping on LP gas is normal.

Specified input rates are as shown in figures 17 and 18.

5 BURNER MODEL

FIGURE 17

JENN-AIR 30￿

INPUT RATES - NATURAL GAS / LP GAS (BTU/HR)

BURNER LOCATION

Hi

Lo

Right Front

15,000 / 15,000

2000 / 2000

Right Rear

9,200

/ 9,100

1450 / 1550

Left Front

5,000

/ 4,000

650

/ 850

Left Rear

10,500

/ 9,100

1450 /

1550

 

 

 

 

 

FIGURE 18

JENN-AIR 36￿

INPUT RATES - NATURAL GAS / LP GAS (BTU/HR)

BURNER LOCATION

Hi

Lo

Right Front

12,500 / 10,500

1450 / 1600

Right Rear

5,000

/ 4,000

650 / 850

Left Rear

5,000

/ 4,000

650 / 850

Left Front

9,200

/ 9,100

1450 / 1550

Center

17,000 / 15,000

2000 / 2000

 

 

 

 

11

Image 11
Contents Dimensions Cutout Dimensions Are CriticalImportant Preparation Suggestions Installing Cabinetry Over Your Jenn-Air CooktopRequired Adjustments At Time Of Installation Location Of Your Jenn-Air ApplianceRecreational Park Trailers Installation Of ApplianceMobile Homes Illustrative GAS Supply Piping Connecting Appliance To Gas SupplyIf no Other Appliance is to be Installed below this Cooktop Wall Oven Installed below 30 Cooktop Electric Wall Oven Installed below this CooktopIllustrative Alternative Piping Pressure TestingElectrical Grounding Instructions Electrical Wiring InformationReplace ALL Orifice Spuds Converting Appliance For Use With LP GasView Through Knob Hole Conversion of Appliance Pressure RegulatorFlame Appearance AT HI and LO To Convert Appliance For Use With Natural GasBurner Ignition Auto-Reignition Reset the Valves for Natural GASLAS Dimensiones DE Corte DEL Hueco SON DE Suma Importancia DimensionesUbicación del electrodoméstico Jenn-Air Instalación del electrodoméstico Casas móvilesVehículos recreativos Caja DEL Quemador Conexión del electrodoméstico al suministro de gasIlustración DE LA Tubería DEL Suministro DE GAS Nota, en referencia a la Figura 4 anterior Ilustración DE LA Tubería Alternativa Pruebas de presiónInstrucciones eléctricas de conexión Tierra Información de cableado eléctricoColoque DE Nuevo Todos LOS Puntales DE Orificio Conversión del electrodoméstico para usarse con gas LPInstalación DE LOS Puntales DE Orificio Obturadores Remoción DEL Puntal DE OrificioChaflán Superficie Orientado DE Vidrio Conversión DEL Regulador DE Presión DEL ElectrodomésticoInstalación de los puntales de orificio de gas Natural Apariencia DE LA Llama EN Alto BajoReajuste LAS Válvulas Para Usar GAS Natural Encendido del quemador y reencendido automáticoRespecter Impérativement LES Dimensions DE LA Découpe Manuel DE Mise EN ServicePréparation du comptoir Emplacement de votre appareil Jenn-AirRéglages requis lors de la mise en service Suggestions de préparation importantesPose de l’appareil Maisons mobilesRoulottes de parc Boîte DES Brûleurs Raccordement de l’appareil au gazIllustration D’UNE Conduite DE GAZ Remarque concernant la ci-dessus Illustration D’UNE Méthode Alternative Vérification de la pressionCâblage électrique AvertissementRemplacer Tous LES Raccords À Orifice Conversion de l’appareil au gaz GPLPose DE Raccords ET DE Réducteurs DE Débit D’ORIFICE GPL Dépose DE L’ÉCROU À OrificeVUE Dans LE Trou DU Bouton Conversion DU Détendeur DE L’APPAREILApparence DE LA Flamme À Plein FEU ET À FEU Doux Pour convertir l’appareil au gaz naturelAllumage standard et allumage automatique des brûleurs Reconversion DES Commandes AU GAZ Naturel

JGC9536, JGC9430 specifications

The Jenn-Air JGC9536 and JGC9430 are two prominent models in the realm of premium gas cooktops, designed to elevate culinary experiences in the modern kitchen. Both models offer a range of advanced features and technologies that cater to the needs of chefs at all skill levels.

Starting with the JGC9536, this cooktop boasts a powerful 19,000 BTU burner, ideal for rapid boiling and high-heat searing. This feature is complemented by a versatile selection of burner sizes, including a 15,000 BTU dual-flame burner, which allows for precise temperature control. This burner is particularly advantageous for simmering sauces or slow-cooking delicate dishes. Additionally, the JGC9536 incorporates powerful 6,000 BTU burners that are excellent for everyday cooking tasks, providing a good balance between heat and efficiency.

The JGC9430, while slightly smaller, does not compromise on performance. It features a robust 16,000 BTU burner that provides ample power for a variety of cooking methods. Both models are equipped with continuous cast iron grates that allow for easy movement of pots and pans across the cooktop. This design not only enhances stability but also offers a professional look to the kitchen.

A notable technology integrated into both the JGC9536 and JGC9430 is the Precision Temperature Control. This feature provides consistent heat across the burners, ensuring food is cooked evenly. The high-performance ignition system is another highlight, allowing for quick and reliable burner lighting, which is essential for busy kitchen environments.

In terms of aesthetics, both models feature sleek stainless steel finishes and a sophisticated design that complements any kitchen décor. The illuminated knobs on the front provide not only a stylish touch but also practical visibility, making it easy to operate even in low-light conditions.

Safety features are also a focus for both cooktops. The flame-sensing technology automatically re-ignites the burner if the flame goes out, providing peace of mind while cooking. Additionally, the sealed burners minimize the risk of spills and allow for easy cleaning.

In summary, the Jenn-Air JGC9536 and JGC9430 gas cooktops are top-tier choices for those seeking to enhance their cooking experience. With powerful burners, advanced temperature control technologies, and a commitment to safety and aesthetics, these cooktops stand out as excellent investments for any kitchen. Whether for everyday cooking or culinary adventures, these models deliver exceptional performance and versatility.