Pitch of beep tone at the end of heating cycle

PAD	INSTRUCTION	DIGITAL DISPLAY WINDOW
5	Within 3 seconds after pressing Prog pad at step 4, press Start pad.
	 “PROG” will start to blink.
	The display changes to 1st, 2nd, and 3rd each time the Start pad is
	pressed and the settings change.
	*The length of beep tone at the end of heating cycle
	1st : 3 beeps
	2nd : short beeps for 60 seconds
	3rd :“Beep” sounds for 5 seconds, and then 3 beeps sound 30 seconds
	later and again 60 seconds later.
	(Buzzer reminder functions to prevent food forgotten in the oven)

6	Press Prog pad.
	 “PROG” will stop blinking, and the set length of beep tone at the end of
	heating cycle will appear for 3 seconds.
	Then “0” will appear.

To proceed to Step 7, press Start pad before “0” is displayed after Step 6.

7	Within 3 seconds after pressing Prog pad at step 6, press Start pad.
	 “PROG” will start to blink.
	The display changes to “ ”, “ ”, and “ ” each time the Start pad is
	pressed and the settings change (Under the “bE” in “bEEP”).

	*The pitch of beep tone at the end of heating cycle
	: Low,	: Normal,	: High

8	Press Prog pad.
	 “PROG” will stop blinking, and the set pitch of beep tone at the end of
	heating cycle will appear for 3 seconds.
	Then “0” will appear.

To proceed to Step 9, press Start pad before “0” is displayed after Step 8.

9	Within 3 seconds after pressing Prog pad at step 8, press Start pad.
	 “PROG” will start to blink.
	The display changes to “ ”, “ ”, and “ ” each time the Start pad is
	pressed and the settings change (Under the “EP” in “bEEP”).

	*The pitch of filter cleaning alarm
	: Low,	: Normal,	: High

10	Press Prog pad.
	 “PROG” will stop blinking, and the set pitch of filter cleaning alarm will
	appear for 3 seconds.
	Then “0” will appear.

Note: When the filter cleaning alarm counter setting is “0”, you cannot perform steps 9 and 10.

- 16 -

*The length of beep tone at the end of heating cycle