Installation Instructions for Stacking
IMPORTANT
1.Disconnect the power cord from the wall socket before attempting installation.
2.For stacking installation, you must use the PANASONIC Joint Plate (sold separately).
3.The combination of the units for stacking is limited to only the following PANASONIC models:
Models No.
4.The maximum stacking height is the total heights of two units.
PREPARATION
Be sure the oven cavity is empty. Be sure surfaces where ovens meet is clean and sanitized.
INSTALLATION
1.Stack the units and remove five screws (a) as shown in Fig.1.
2.Loosen the screw (b).
3.Projection on Joint Plate must face away from the oven. Place Joint Plate on the screw (b).
4.Attach and tighten five screws (a) and the screw (b). See Fig.2.
5.Ensure the top oven is at a safe and workable height.
(b)
Joint Plate
Projection | Joint Plate |
Projection 
(a)
Fig. 1 | Fig. 2 |
Sanitary Counter Top Seal
When microwave oven units are stacked on a counter top, their base must be sealed in accordance with NSF Standards as per the following instructions.
1.Microwave oven should be located on a level counter top surface. Complete the electrical connections.
2.Thoroughly clean the microwave oven bottom perimeter and the counter top area around the microwave oven perimeter.
3.Lay generous bead of silicone seal around the entire perimeter of the base of each microwave oven unit.
4.Smooth the silicone seal into the crevice with finger
or tool to provide a cove seal.
Note: Remove the Air Filter from the front of the oven before applying silicone.
DO NOT FORGET to
Silicone Sealant
Counter Top
- 21 -