Middleby Marshall Oven owner manual Checking Track Rail Alignment, Trim Strip Positioning

SECTION 2

INSTALLATION

5.Check the alignment of the track rails using a straightedge. The rails MUST BE LEVEL across the gap between the ovens. If necessary, adjust the oven legs to align the track rails.

Figure 2-19

Checking Track Rail Alignment

6.Tighten all of the attaching bolts. Check that the mating edges of the ovens align properly. If gaps appear between the tops of the ovens, it will be necessary to loosen the connecting bolts and realign the ovens.

IMPORTANT: If it is necessary to realign the ovens, remember to re-check the alignment of the track rails.

7.Attach the front trim strip between the two ovens, as shown in Figure 2-20.

Trim strip

Figure 2-20

Trim Strip Positioning

8.Perform one of the following, as appropriate:

•For PS360/360WB Tandem and Double Tandem installations, skip ahead to the INSTALLING THE CONVEYOR FRAME AND BELT section (Page 2-19).

•For PS360/360WB Tri Tandem installations, perform Steps 1-7 again to attach the third oven to the two that have just been assembled. Then, skip ahead to the

INSTALLING THE CONVEYOR FRAME AND BELT section (Page 2-19).

•For PS360/360WB Quad Tandem installations, perform Steps 1-7 again to attach the two remaining ovens to each other. Then, continue on to Step 9 to attach the center (transition) section.

2-16