Middleby Marshall Oven owner manual 25a, Installing the Conveyor Frame and Belt

Page 19

SECTION 2

INSTALLATION

INSTALLING THE CONVEYOR FRAME AND BELT

FOR ALL TYPES OF OVENS, ENSURE THAT THE DRIVE

SECTION/END OF THE CONVEYOR FRAME IS PLACED ON

THE SAME END OF THE OVEN AS THE CONVEYOR DRIVE

MOTOR.

1.Insert the conveyor frame into the oven as follows:

For a TANDEM or DOUBLE
TANDEM oven, slide the conveyor
frame assembly into either end of	Figure 2-25a
the oven.	Figure 2-25a
	Installing the Conveyor Frame-
	Tandem and Double Tandem Ovens

For TRI TANDEM ovens, slide one center section and one end section of the frame into EACH END of the oven. The four sections should butt against each other.

Figure 2-25b

Installing the Conveyor Frame-

Tri Tandem Ovens

For QUAD TANDEM ovens, slide two intermediate sections and one end section of the frame into EACH END of the oven. Butt the two inner intermediate sections against the transition (center) frame section. The other

frame sections should butt against each other.

Figure 2-25c

Installing the Conveyor Frame-

Quad Tandem Ovens

2-19

Image 19

Contents UNLOADING/UNPACKING Section InstallationVentilation Hood Dimensions Recommendations only II. INSTALLATION, PREPARATION, and SupplyOther Ventilation Concerns III. Ventilation SystemRequirements RecommendationsInstallation KIT Dimensions and Data PS360L Tandem Dimensions and Data PS360WB Double Tandem Dimensions and Data PS360U Tri Tandem Dimensions and Data PS360WB-U Tri Tandem Dimensions and Data PS360U Quad Tandem Dimensions and Data PS360WB-U Quad Tandem Thermocouple Installation Locations IV. Thermocouple InstallationPlacing the Thermocouple Leads Thermocouple Lead Connections Exploded View Upper Oven Stand AssemblyCooling Fan Removal Oven Positioning and AlignmentJoining the Oven Bodies Bolts and Spacers Aligning the Ovens for AssemblyTrim Strip Positioning Checking Track Rail Alignment22a Support Brackets Lower Oven Transition Frame PlacementReplacing Transition Frame Installing the Transition Floor Panel25a Installing the Conveyor Frame and BeltInside Master Links Conveyor Link OrientationOutside Master Links Conveyor Motor and Drive Chain Assembly Transition AssemblyDo not USE Conduit For Ground GAS Supply Electrical SupplyOven Rough-In VI. Electrical Connection Typical Oven Data Plate Models PS360/PS360WB During Pressure Testing Note ONE Following Flexible Hose Connector InstallationVII. GAS Supply for GAS Heated Ovens For USE with Natural GAS VIII. Preparation for Various GasesFor USE with Liquid LP GAS GAS Type and Pressure Label Burner/Piping AssemblyIX. Changing Orifices Volumetric MethodTo Check GAS Supply Pressure XI. Variations of Rated Supply PressuresOrifice Manifold Pressure Method Special Notices