Disassembly Procedures
!WARNING
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitors before following any disassembly procedure.
NOTE: All procedures are written for the ACO18*, JMV8196*, MMV4184, and MMV5186* models. Specific instruction for the ACO15*, MMV5156* models are as described in the procedures.
High voltage is present at the high voltage terminal of the high voltage transformer during any cooking cycle.
It is neither necessary or advisable to attempt measurement of the high voltage.
Before touching any oven components or wiring, always unplug the oven from its power source and discharge capacitor.
Door Removal
1.Disconnect power to oven and remove grille, (see "Grille" procedure).
2.Open the oven door, slowly raise the door evenly. disengaging the pins at the top and bottom.
NOTE: When aligning the door for assembly, the door
must be opened as much as possible.
3.To place door back on unit, place bottom pin into hole first and then align the top pin. Once pins are aligned push door downward to lock into place.
4.Replace front grille to complete assembly.
Grille
The top
Grille Removal
1.Disconnect power to oven.
2.Remove screws located in front on top of microwave securing grille.
3.Pull outward on the top portion of the grille releasing the tabs.
4.Reassemble in reverse order.
Door Assembly
!CAUTION
A microwave leakage test must be performed anytime a door assembly is removed, replaced, disassembled or adjusted for any reason.
Door Disassembly
1.Disconnect power to oven and remove oven door, (see "Door Removal" procedure).
2.Pry away choke cover, by placing a tool in the upper right corner of the door and gently prying outward on the choke cover. Continue to work around the door casing until choke cover is completely loose.
!CAUTION
To avoid property damage, care must be taken when prying choke cover from oven door.
3.Slide latch assembly upward and to the left to release plastic tabs from door frame. Once latch assembly is loose the spring may be disconnected from the door frame.
4.Remove screws securing door handle and door frame to door panel.
5.Remove door frame by releasing tabs around entire door panel.
16021668 Rev. 0 | 18 | ©2002 Maytag Appliances Company |