Maytag ACO1560AC, ACO1840AC, ACO1560AB Cooktop/Night Light Replacement, Oven Light Replacement

Page 43

Care and Cleaning

4. Remove old filter.

5.Slide new charcoal filter into place. The filter should rest at the angle shown.

6.Slide the bottom of the vent cover into place. Push the top until it snaps into place. Replace the mounting screws. Turn the power back on and set the clock.

Cooktop/Night Light Replacement

1.Unplug the oven or turn off power at the main power supply.

2.Remove the bulb cover mounting screws.

3.Replace bulb(s) with 30 or 40 watt appliance bulb(s).

4.Replace bulb cover.

5.Turn the power back on at the main power supply.

Oven Light Replacement

1.Unplug oven or turn off power at the main power supply.

2.Remove the vent cover mounting screws. (2 middle screws)

3.Tip the cover forward, then lift out to remove.

4. Remove bulb holder mounting screw.

5. Lift up the bulb holder.

6.Replace bulb with a 30 or 40 watt appliance bulb.

7.Replace the bulb holder and mounting screw.

8.Slide the bottom of the vent cover into place. Push the top until it snaps into place. Replace the mounting screws. Turn the power back on at the main power supply.

©2002 Maytag Appliances Company

B–3

16021668 Rev. 0

Image 43
Contents Service Web Site Telephone Number Customer Service Support CenterRecognize Safety Symbols, Words, and Labels Important InformationTable of Contents Servicing of Grounded Products WiringImportant Product Information Grounding InstructionsImportant Safety Information Microwave Leakage Testing General Information Vent grille Microwave Oven DescriptionOven control Testing Procedures Relay High Voltage CapacitorHigh Voltage Diode Humidity SensorACO1840/MMV4184 models Pad Conn ACO1520/ACO1530 models Pad ConnACO1560/MMV5156 models Pad Conn ACO1560/MMV5156 modelsFan Motor Circuit BoardOven Thermostat FuseTroubleshooting Procedures Adjust or Wire across Replace high Thermostat When Start pad is Check Power Supply Fuse Grille Disassembly ProceduresDoor Assembly Door DisassemblyRelay ACO1520*, ACO1530*, and MMV5156 Control PanelBoard Control Panel RemovalRelay Power TransformerOuter Case Screw Control Panel Circuit BoardInterlock Door Latch Switches Stirrer Assembly some modelsHigh Voltage Capacitor Removal Adjusting InterlocksDiode ACO1840*, ACO1860*, JMV8196 MMV4184*, and MMV5186Fuse Removal Magnetron Fan AssemblyPower Transformer Removal TransformerHumidity Sensor Removal Magnetron Thermal FuseMagnetron Thermal Fuse Fan MotorVent Blower Base ThermostatLight Socket Turntable MotorWiring Diagram and Schematic ACO1560* and MMV5156* Models ACO18*, JMV8196*, MMV4184, and MMV5186* Models Appendix a Installation InstructionElectrical rating of this oven 120V AC 60Hz Avoid Electrical ShockDo not USE the Microwave Oven Do not expose yourself to excessive microwave energyParts, Tools, and Materials Tools and materials required for installationFollowing parts are supplied with the oven Roof Venting Preparing Electrical ConnectionPreparing Venting System Roof-VentingStandard Fittings Ductwork Length Room VentingPreparing Venting Blower Roof Venting InstallationWall Venting Installation Room Venting Installation RecirculatingPreparing Wall and Upper Cabinet Preparing Template PlacementDrilling Holes in the Wall and Upper Cabinet Installing Mounting PlateAttaching Oven to the Wall Damper This page intentionally left blank Appendix B Cleaning the Grease Filters Care and CleaningCharcoal Filter Replacement Oven Light Replacement Cooktop/Night Light Replacement