Disassembly Procedures
!WARNING
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitors before following any disassembly procedure.
9. Reassemble in reverse order.
Vent plate |
Power cord cover |
Door |
Mounting |
plate |
Outter case |
Vent grille |
Controller |
Stirrer Assembly (some models)
Motor driven antenna assembly is located at the top of the cavity, using a top feed wave guide.
Stirrer Blade Removal
1.Disconnect power to oven and open the oven door.
2.Carefully pry downward on the plastic rivets securing the stirrer cover.
3.Rotate slightly and pull down on stirrer fan cover .
4.Reassemble in reverse order.
ACO1840*, ACO1860*, JMV8196*, |
MMV4184*, and MMV5186* |
Interlock Door Latch Switches
Primary switch is operated by bottom latch pawl.
Interlock Switch Removal
1.Disconnect power to oven and remove control panel, (see "Control Panel" procedure).
2.Discharge high voltage capacitor, (see "High Voltage Capacitor" procedure).
3.Test interlock switches before removing, (see Testing Procedures).
4.Disconnect and label wire connections.
5.Remove interlock switch.
Latch Board
Secondary Interlock Switch
WH (from H.V. Transformer) 
WH (from Monitor S/W)
WH (from Oven Thermostat) 
WH (from Cooktop Lamp)
Monitor Interlock Switch
WH (from Secondary switch)
RD (from Relay 7) 
Primary Interlock Switch
GN (from P.C.B)
YL (from P.C.B) 
ACO15020*, ACO1530*, and MMV5156*
©2002 Maytag Appliances Company | 21 | 16021668 Rev. 0 |