Maytag ACO1560AS, ACO1840AC, ACO1560AB Do not expose yourself to excessive microwave energy

Page 31

Installation Instruction

!WARNING

If you do not use the microwave oven as instructed, you could be exposed to excessive microwave energy.

Do not expose yourself to excessive microwave energy!

DO NOT try to operate the microwave oven with the door open.

DO NOT tamper with or defeat the safety interlocks.

DO NOT place objects between the microwave oven front face and the door.

DO NOT allow soil or cleaner residue to build up on the flat surfaces around the microwave oven door.

DO NOT operate the microwave oven if it is damaged.

The microwave oven door must close properly to operate safely.

DO NOT USE THE MICROWAVE OVEN:

If the door is bent.

If the hinges or latches are broken or loose.

If the door seals, sealing surfaces or glass is broken.

DO NOT ATTEMPT TO ADJUST OR REPAIR THE OVEN YOURSELF!

It should be adjusted and repaired by a qualified technician who can check for microwave leakage after repairing the oven.

!WARNING

If you do not mount the oven as instructed, you risk personal injury and/or property damage.

!CAUTION

Before you begin installing the oven, PLACE A PIECE OF THE CARTON OR OTHER HEAVY MATERIAL (a blanket) over the countertop or cooktop to protect it.

Do not use a plastic cover. Failure to protect these surfaces could result in property damage.

Make sure you have enough space and support.

Mount the oven against a flat, vertical wall, so it is supported by the wall. The wall should be constructed of minimum 2" x 4" wood studding and 3/8" thick drywall or plaster/lath.

ATTACH AT LEAST ONE of the two lag screws supporting the oven to a vertical, 2" x 4" wall stud.

DO NOT mount the microwave oven to an island or peninsula cabinet.

BE SURE the upper cabinet and rear wall structures are able to support 150 lbs., plus the weight of any items you place inside the oven or upper cabinet.

Locate the oven away from strong draft areas, such as windows, doors, and strong heating vents.

BE SURE you have enough space. See illustration below for minimum vertical and horizontal clearance.

This microwave oven can be installed over gas or electric cooking products no more than 36 inches wide.

13- 9/16" min. microwave oven to cooking surface or

countertop

Grounded Outlet (inside upper cabinet)

Power Supply Cord Hole

30" min. cabinet opening width

30" min. clearance from bottom of cabinet to cooking surface or countertop

(Use templates included

with installation instructions)

Maximum gas or electric cooking product width of 36 inches.

©2002 Maytag Appliances Company

A–3

16021668 Rev. 0

Image 31
Contents Service Web Site Telephone Number Customer Service Support CenterRecognize Safety Symbols, Words, and Labels Important InformationTable of Contents Servicing of Grounded Products WiringImportant Product Information Grounding InstructionsImportant Safety Information Microwave Leakage Testing General Information Vent grille Microwave Oven DescriptionOven control Testing Procedures Relay High Voltage CapacitorHigh Voltage Diode Humidity SensorACO1840/MMV4184 models Pad Conn ACO1520/ACO1530 models Pad ConnACO1560/MMV5156 models Pad Conn ACO1560/MMV5156 modelsFan Motor Circuit BoardOven Thermostat FuseTroubleshooting Procedures Adjust or Wire across Replace high Thermostat When Start pad is Check Power Supply Fuse Grille Disassembly ProceduresDoor Assembly Door DisassemblyRelay ACO1520*, ACO1530*, and MMV5156 Control PanelBoard Control Panel RemovalRelay Power TransformerOuter Case Screw Control Panel Circuit BoardInterlock Door Latch Switches Stirrer Assembly some modelsHigh Voltage Capacitor Removal Adjusting InterlocksDiode ACO1840*, ACO1860*, JMV8196 MMV4184*, and MMV5186Fuse Removal Magnetron Fan AssemblyPower Transformer Removal TransformerHumidity Sensor Removal Magnetron Thermal FuseMagnetron Thermal Fuse Fan MotorVent Blower Base ThermostatLight Socket Turntable MotorWiring Diagram and Schematic ACO1560* and MMV5156* Models ACO18*, JMV8196*, MMV4184, and MMV5186* Models Appendix a Installation InstructionElectrical rating of this oven 120V AC 60Hz Avoid Electrical ShockDo not USE the Microwave Oven Do not expose yourself to excessive microwave energyParts, Tools, and Materials Tools and materials required for installationFollowing parts are supplied with the oven Roof Venting Preparing Electrical ConnectionPreparing Venting System Roof-VentingStandard Fittings Ductwork Length Room VentingPreparing Venting Blower Roof Venting InstallationWall Venting Installation Room Venting Installation RecirculatingPreparing Wall and Upper Cabinet Preparing Template PlacementDrilling Holes in the Wall and Upper Cabinet Installing Mounting PlateAttaching Oven to the Wall Damper This page intentionally left blank Appendix B Cleaning the Grease Filters Care and CleaningCharcoal Filter Replacement Oven Light Replacement Cooktop/Night Light Replacement