Done?

Page 23

PROGRAMMING THE BREWER (cont.)

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.) Procedure for Setting the Recipe:

NOTE: Before beginning setup, place a server beneath the brew funnel.

1.Insert the funnel into the grinder and select the small batch size to grind. It is not necessary to have coffee beans in the hopper(s) in order to program the brewer. The coffee name is pre-selected and stored in the grinder’s memory for the side being ground.

2.Press the GRIND pad. When the grinder stops grinding, remove the funnel.

3.On the brewer, press and hold the right hidden but- ton until the display reads SET LANGUAGE. Press and release the right hidden button until the display reads SET NEW RECIPE. Release the right hidden button.

4.Press and release YES. The display should read INSERT FUNNEL WITH NEW NAME, then QUIT SET- UP? These two displays will repeatedly cycle.

5.Insert the funnel into the rails on the brewer. The display should read the name of the coffee that was ground into the funnel, along with a NO and YES. If the name on the display is correct, press YES.

6.If, for some reason, the name of the coffee from the grinder did not load properly into the funnel, or if a grind has not yet been done, the display will read MUST GRIND INTO FUNNEL FIRST. It will be necessary to grind another batch following steps 1 and 2.

NOTE: If brewer memory is full, the display will read RECIPE STORAGE AREA IS FULL and then REMOVE A FLAVOR? To remove a recipe press and release YES. Press NEXT to scroll through the stored recipes. When the display reads the name of the recipe to be removed, press and release REMOVE. The display will read REMOVE? Press CANCEL to exit the SET NEW RECIPE function. Press OK to remove that recipe. The display will then show BEGIN SETUP OF (COFFEE NAME). Continue with step 7.

7.If the grind is acknowledged by the brewer, the display will read BEGIN SETUP OF (COFFEE NAME). Then the screen will display BREW OZ and a batch light will be blinking. (Refer to page 34 for descrip- tion of BREW OZ function).

8.Using (-)and (+), set the amount of brew water to be dispensed for that batch size.

9.When finished, press the other batch size and repeat step #8.

10.When finished setting both batch sizes, press and release DONE. The display should read 2 BATCHES

11.If both batch sizes are not correct press and release NO to return to the BREW OZ setup screen and repeat steps #8, 9 and 10.

12.If both batch sizes are correct, press and release YES to advance to the SET PULSE BREW function. (Refer to page 35 for description of the SET PULSE BREW function.

13.To SET PULSE BREW press YES and proceed with the setup instructions for SETTING PULSE BREW, on page 35.

14.To skip setting the PULSE BREW and to use the FACTORY DEFAULTS, press NO to proceed to the DRIP TIMES function.

BREW OZ XX.X

(-) DONE (+)

BREW	BREW	BREW
A	B	C

SET PULSE BREW

NOYES

BREW	BREW	BREW
A	B	C

DRIP TIME XX.X

(-) DONE (+)

BREW	BREW	BREW
A	B	C

(COFFEE NAME)

SETUP COMPLETE

5 SEC.

THAT WAS THE

LAST RECIPE

P2855

MASTER TEMP XXX°

NOYES

36748 051304