CDA RC 9000 installation instructions Oven light, Traditional convection cooking

Page 14

Fig. 15

Fig. 16

Thermostat knob (Fig. 16)

This only sets the cooking temperature and does not switch the oven on. Rotate clockwise until the required temperature is reached (from 50 to 250°C).

The light between the thermostat and the function selector will illuminate when the oven is switched on and turns off when the oven reaches the correct temperature.

The light will cycle on and off during cooking in line with the oven temperature.

Function selector knob (Fig. 15)

Rotate the knob clockwise to set the oven for one of the following functions.

Oven light

By setting the knob to this position, only the oven light comes on. It remains on in all the cooking modes.

Traditional convection cooking

The upper and lower heating elements come on. The heat is dispersed by natural con- vection and the temperature must be set to between 50° and 250°C via the thermo- stat knob.

The oven must be preheated before cooking.

Recommended for:

Food that requires the same degree of cooking both inside and out, for example roasts, spare pork ribs, meringues etc.

14

Image 14
Contents Dual fuel Cookers CDA Contents Introduction Assembling the backguardFeatures and technical data Gas burnersControl panel Control Panel Controls descriptionElectronic programmer Electronic clock fig Electronic timerAltering the audible signal Normal cooking without the use of the programmerAutomatic oven cooking Semi-automatic cooking Electric ignition How to use the hob burners Hob burners Lighting of the hob burnersChoice of burner Correct use of triple-ring burnerOperating principles How to use the Multifunction ovenGeneral features Oven light Traditional convection cookingHot air cooking GrillingDefrosting frozen foods Ventilated grill cooking Convection cooking with ventilationSimultaneous cooking of different foods SterilizationRegeneration Use of the grill Grilling and au gratinRoasting Important notes Do’s and do not’s For your safetyDo’s and do not’s Care and maintenance Flexible tubeEnamelled parts Burners Triple ring burnerRemoval of the inner glass door panel Storage compartmentInside of oven Assembling and dismantling of the side runner framesOven tray Door assembly Removing the oven doorFor Installer Location Fitting the adjustable feet Levelling the cooker Stability bracket Provison for ventilation Gas installation Important NoteInstallation to Natural Gas Gas connectionPlug 200 mm 700 mm Injectors replacement of top burners Conversion to Natural Gas or to LPGAdjusting of the minimum of the top burners Lubrication of the gas taps Table for the choice of the injectorsFeeder cable section Electrical installationConnecting feeder cable Appliance servicing Guarantee Limit of CoverRC 9000 .. cookers